Question about Canon CA-590 Compact Power Adapter (1887B002)

1 Answer

Canon CA-590 compact power adapter

Tip / prong that plugs into the camera broke. Can this be repaired? Cannot afford price of a new adapter.
Thanks,
Bea

Posted by on

  • rkramer100 Dec 25, 2008

    I just need a new tip plug for the Canon CA 590, not a whole unit. If you have a cable from a defective transformer part, I would like to buy it. If you have a plug I can attach, I want to buy it. the price of the ca 590 is more than I paid for the whole camera.



    thanks

  • rkramerzo100 Feb 03, 2009

    I just need the tip... I have other adapters of that voltage and current, including older canon ones that just need the proprietary tip plug.



×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Have that adapter tested, found defective diode sb260 near dc output, however after replacing different specs of diode it powered up then diode was busted again.

Posted on Mar 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Selphy cp780 continues to say ink cartridge empty even after installing new one. Tried 2 new ones to be certain it wasn't the cartridge, same thing...tells me ink cartridge empty install new.


try and reset your printer,unplug the power cord and wait 10 min, then plug back in,understand that Canon has installed a chip so you cannot use refilled cartridges,or cartridges you refill,if this doesn't work,then contact Canon,and you could get the same message I got take it in to be repaired, (to costly), so I end up buying a new one,,

Oct 10, 2012 | Canon SELPHY CP780 COMPACT PHOTO...

1 Answer

Smudge showing up in view finder and on photo PowerShot SX210


Is there a visible smudge on the front element of the lens? If so, you can use a LensPen or cleaning cloth from the photo department of your favorite store.

There is the possibility that there is fungus growing inside the lens elements of the camera. Humidity can allow this to happen over time with camera lenses as well.

If you have fungus inside the lens, you may need to check with a repair shop... buying a new camera may be in your future.

Jun 19, 2012 | Canon Slim Camera Case(11160306581) for...

1 Answer

Cannon adapter used in a cannon printer is suspected of failing. P/N K30268 Where is a cannon service center in San Jose, Ca that could plug into suspected adapter to check power output?


I don't think cannon usage is very popular in San Jose (too liberal). You might try looking for a Canon service center instead.

Jul 06, 2011 | Canon AC Adapter

1 Answer

I have a Sigma lense 500 APO Canon fit, I would like to make it fit my Nikon/Kodak DCS Pro is there a converter/adapter for the job or is this lense not adequate for this purpose - Many thanks.


Unfortunately, no. Nikon bodies are deeper than Canon bodies. This allows an adapter to fit a Nikon lens on a Canon body, but going the other way prevents the lens from focusing to infinity.

Dec 16, 2010 | Canon Digital Camera Accessories

1 Answer

Canon powershot a an error message E18 comes on. . .whats this mean?


If your camera is still under warranty, the best thing you can do is to take it to the nearest official Canon repair shop and Canon should fix it for free.

If your camera is out of warranty, or if Canon refuses to repair it for free (happens sometimes if for example they suspect the camera has not been treated properly) you can try some of the methods listed here to repair it yourself. These simple methods have helped a lot of people fix their cameras.

Before trying any of the suggestions, make sure your Canon has fresh batteries and it is in recording mode.

1) Remove the batteries from the camera, wait for a couple of minutes, then put them back in and turn the camera on.

2) Try compressed air. With a fine tip blow off gun and dry compressed air (20 lbs) set the tip between the lens turret and the camera body and turn on the air while moving the tip around the lens. It should remove all dust and sand. Turn the camera on and it should function fine.

3) Another method is to tap the padded USB cover part on a hard surface, for example, a desk. It sounds so simple, but very often in works.

4) Try forcing the camera lens:

Turn off the camera. Place it on the back with the lens facing up and take a look at the spacing between the lens and the lens housing. If you notice that the gap is not even all the way around the lens, the problem should be easy to fix. This type of a problem usually occurs if the camera was dropped while the lens was extended.

Simply - VERY GENTLY - press down the lens on the side where the gap is the biggest. You should hear a "click" as it pops back into place. Try powering the camera back on.

If the lens doesn't extend at all or it extends, and then retracts again, do the following. Turn the camera off. Take the camera in one hand and with the other gently take one part of the lens and gently move it round in a circular movement. Do so with both sections of the lens. You will hear a "click" as it pops back in place. Power the camera on.

Another version of this fix would be to pull and twist on the largest ring of the lens while turning the camera on. Listen for a "click". If at first the focus seems to be off, turn the camera on and off and take lots of pictures, close ups and distance. Focus should slowly start improving.

5) If that doesn't work, there is an online guide for dismantling Canon cameras and fixing the E18 error. (NOTE: Try this only if your camera is no longer under warranty!) It is a great guide with pictures and it can be found here.

There are 2 other guides, one Bulgarian and one Estonian with the take apart procedure for Canon cameras. They are not in english but have a lot of pictures which help with the process.

Jan 20, 2010 | Canon Digital Camera Accessories

1 Answer

Cannon 590 is say card is locked wont let me take a pic how do i fix this


Remove the SD memory card and look at the front (side opposite the connectors), and on the left side is a slide switch. It should be in the UP position.

Dec 23, 2009 | Canon Digital Camera Accessories

1 Answer

SmartdiskUniversal Reader Model #61N1USB.


About the time you replace the reader, you will have enough money to buy a new one.

Nov 20, 2009 | Canon Digital Camera Accessories

1 Answer

I think my battery clip to hold down my battery is broke on my kodak easyshare z760


You should experience an intermittedly no power fault is so.

You can order a repair though KODAK a batt clip repair price is 24,47 pounds.

Alternative try some strong tape.

Contact KODAK:
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=14563&pq-locale=en_US&_requestid=3490

Mar 09, 2009 | Kodak Digital Camera Accessories

Not finding what you are looking for?
Canon CA-590 Compact Power Adapter (1887B002) Logo

Related Topics:

666 people viewed this question

Ask a Question

Usually answered in minutes!

Top Canon Digital Camera Accessories Experts

kakima

Level 3 Expert

96683 Answers

old marine
old marine

Level 3 Expert

1479 Answers

Jorge Luis
Jorge Luis

Level 2 Expert

198 Answers

Are you a Canon Digital Camera Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...