Question about Samsung HCL4715W 47" Rear Projection Television

1 Answer

All screen is red

I bought HCL4715W 6 years ago, and fixed convergence problem 2 years ago (I think replaced convergence IC). Few month ago, it starts showing colors redish. Now screen is all red, and I can not see anything but red screen. I wonder what is the problem and how I can fix.

Posted by on

  • Anonymous Dec 01, 2008

    I think I have the same problem. Tv works good with nice picture, but I am getting red flickering, and red horizontal flickering lines. Can someone give more detail on this

  • samuraiRS Dec 09, 2008

    I think I have the same problem the other guest is having. Picture comes out fine, but I get flickering red horizontal lines on the screen. If I choose an input with no signal, ie. a turned off cable box, I still see the red flickering lines (even though it's just a black screen in the background). Any possible solution to this?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

IF THE SCREEN IS ALL RED WITH VIDEO VISIBLE AND RETRACE LINES. ADJUST SCREEN CONTROL IN THE FRONT FOR THE RED TUBE ONLY. TURN CONTROL COUNTER CLOCKWISE. IF THAT DOESNT DO IT THE TUBE CAN BE REJUVINATED.

Posted on Nov 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a Samsung rear projection TV, not sure what model number or anything, it is about a 42 inch and about 6 years old now. The problem first started several months ago, basically when the TV was turned...


sounds like the convergence chip. i think you can get a kit from tvrepairkits.com not sure how much it would be to have fixed. But if your good with a soldering iron i think their kits come with instructions as well.

May 18, 2009 | Samsung HCL4715W 47" Rear Projection...

1 Answer

Power light is on T.V. is not responding


u may have a bad convergence board stk392-040

Apr 30, 2009 | Samsung HCL4715W 47" Rear Projection...

2 Answers

Anyone need any parts for the HCL4715W? Parting mine out.


More then likely set has 2 burt resistors on convergence board 2.7ohms

Jan 27, 2009 | Samsung HCL4715W 47" Rear Projection...

1 Answer

HOW TO FIX CONVERGENCE IC FAULT & HOW MUCH COST APPROX


Panasonic Flashing codes:
1: ----------------- +140 v.
2: ----------------- Low DC
3: ----------------- Convergence
4: ----------------- HHS
5: ----------------- IC 4011
6: ----------------- IC 4018
3 is convergence, either one of the two convergence ICs faulty, or something else (capacitor etc.) has blown on convergence board.

Jul 13, 2008 | Projection Televisions

1 Answer

Red lines on screen


REPLACE THE CONVERGANCE IC"S.STK392

Dec 23, 2007 | JVC AV-48WP30 48" Rear Projection...

1 Answer

Internal Screen Adjustments No Response


thr focus block assy.has the screen and focus controls on it it about 3"x3" in size has red wires attached to it and one feeding form the flyback transformer to it.

Aug 29, 2007 | Samsung HCL4715W 47" Rear Projection...

5 Answers

Toshiba TP55H60 power down after start up


Try the following
1-unplug tv
2-remove bottom cover on tv
3-tap the power supply frame a few times (where the power cord enters the tv)
I had the blinking red light on my tv. I tried other solutions like removing the red wire a few times etc. Tapping the power supply frame solve the problem.

Aug 11, 2007 | Toshiba TP55H60 55" Rear Projection...

2 Answers

Is this a calibration, convergence, or lens focusing issue?


Did you Change out the Ground Resistors,220 Ohm,3.3Ohm Even if they look Good Change Them

Jul 20, 2007 | Mitsubishi WS-65869 65" Rear Projection...

2 Answers

Image from HD receiver larger than TV screen


Most satellite boxes have a zoom,stretch mode that might be incorrectly set. i would check that first before dooming an issue with the TV.

Apr 22, 2007 | Samsung HCL4715W 47" Rear Projection...

1 Answer

Blue haze around image, yellow streak


the tv color circuit is off frequency change the color ic take a look on the crystal that gives the 4.8.mhz burst could be that it needs to be replace dont rule out the video IF change the two ICs you mention.good luck.from the look of your tv screen that is my conclusion.good luck.email me at nicodhem@yahoo.com

Apr 04, 2007 | Samsung HC-P4241W 42" Rear Projection...

Not finding what you are looking for?
Samsung HCL4715W 47" Rear Projection Television Logo

Related Topics:

328 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

Donald Griswold
Donald Griswold

Level 1 Expert

8 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Samsung Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...