Question about Car Audio Receivers

1 Answer

Sub not working after installing the jensen vm9022 deck

We installed the vm9022 Jensen radio deck into a 2003 Tiburon. The original radio was an Infinity premium sound system with amp and sub-woofer. After installing the new radio deck we are not getting sound out of the sub. We have cheked and rechecked the wiring and all seems correct. I am guessing that the amp is not getting enough power to turn it on. With the amp buried in behind the rear side panels it is hard to verify that the amp is getting powered on. If we put the old radio back in the sub works again. What do I need to do or check to get the sub to work again?

Posted by on

  • bcrdhome Nov 25, 2008

    we did all of this and it is wired correctly. We went to the local custom audio shop and they claim that factory subs will not work with ant replacement radio. This cannot be true, is it?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 74 Answers

Reinstall the factory radio use a digital volt meter to see witch wire supplies voltage when radio is turned on and off, note placement on harness then verify this wire is hooked up on the output side aftermarket harness you may have to jump it to get the maps to turn on. tip you can carefully pull unused wire from harness example (dimmer wire orange white) and move it to the position needed to keep it a clean install .

Posted on Nov 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I buy the power cord or the wires for the Jensen CD2620Se radio


I would try Ebay first. If not? Try www.Jenson.com I have had luck with them. Or Best Buy..Circuit City. And any Radio installer place in your area has them on hand.

Jan 05, 2011 | Jensen CD2620SE CD Player

1 Answer

Jensen car stereo VM9022 has a password Need to bypass it


call Jensen at 1800-323-4815 they will give you the code

Mar 14, 2010 | Jensen Car Audio Receivers

1 Answer

Jensen VM9312 Installation


Are you saying you need a replacement face plate for this model ?

Jul 13, 2009 | Car Audio Receivers

5 Answers

FM Reception with Jensen MSR3007


I have the exact same problem with the exact same stereo. I started by removing the in-line AM/FM/VHF Separator and connecting the antenna directly to the stereo. The static/popping/fade-out continued. Today I swapped to a new antenna, but it did not help. I swapped back to the original antenna and for a brief while, I had good reception. The I went to coil the excess antenna cable and the static/popping/fade-out resumed. I have narrowed it down to either the antenna connector coming out of the back of the stereo or an internal circuit. Either way, it does not look like a do-it-yourself fix.

May 31, 2009 | Jensen CD400M CD Player

1 Answer

On the jensen vm9022 how do you reverse the subwoofer polarity


CLICK HERE for a copy of your manual in PDF format.

Phase control is featured on page 17 (21 of pdf)

In the Audio Sub-Menu:
Subwoofer Phase Adjustment: Touch the sub.w icon to
access the subwoofer polarity controls and reverse the
subwoofer signal polarity from to 180°. Reversing
polarity can improve bass response related to speaker
configuration.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Apr 06, 2009 | Jensen Car Audio Receivers

1 Answer

Hi,I have a Jensen JHD 1510 and it's not tight in the frame.


SOUNDS LIKE THE CAGE AROUND THE RADIO IS DAMAGED/DEFECTIVE OR THERE ARE TOO MANY WIRES/ NOT ENOUGH ROOM BEHIND THE RADIO PREVENTING IT FROM LOCKING IN FULLY

Nov 13, 2008 | Jensen Car Audio Receivers

1 Answer

Jensen cd 615x


order from jensen or go to a local audio store, ie sound creations,
or a store that installs car stereos, I have had pretty good luck with circut city, best buy is a bit cheaper, but then again you get what you pay for.

Mar 05, 2008 | Jensen CD-615X CD Player

1 Answer

Jensen vm9022


was the unit new or was it a demo? if it was new in a box I would take it back to where you purchased it from and exchange it. some decks the code can be reset such as the case you bought a used car ect., and others you need to replace the code IC in either case you will need to contact jensen custmer service or get the technical schmatic.
good luck stereo tech

Jan 27, 2008 | Car Audio Receivers

1 Answer

Car radio


That wire is an unused spare

Jan 07, 2008 | Jensen CD4610 CD Player

Not finding what you are looking for?
Car Audio Receivers Logo

Related Topics:

442 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio Receivers Experts

xxxxxx xxx

Level 3 Expert

4706 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Car Audio Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...