Question about Computers & Internet

1 Answer

Mecer Xpression EL81 power up problem

My laptop (Mecer Xpression EL81) Power Led goes on when i push the power button, and the fan just goes on for a few seconds than it goes off. Please help!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 348 Answers

Your fan may rotating with insufficient rpm check rpm in set up replace fan if not proper then start again also see another fan replace it if faulty

Posted on Nov 21, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Bestec ATX-300-Z cannot power up. When try to power it up after unplugging from wall outlet, it quickly show green led and the led goes off. I unplugged every connection to the computer, yet it cannot...


I may be wrong, but, seeing that it is only a 250watt power supply, its was probably cheap. NEVER buy cheap power supplies for PC's. Weak PS's can cause damage to multiple components on a computer.

Dec 23, 2010 | Bestec 250Watt Power Supply

1 Answer

Gateway yellow power button, nothing starts, no fan, nothing. opened up computer and see mobo led light is lit. newton ps has a test button. tried to test with various components plugged in and the test...


Power supply has several voltages. Just because the 5v power is active doesn't mean all the voltages are OK. You need to have the power supply tested for 12v and 3.3v. A quick test is to unplug all the wires from the power supply. There is a single green wire on the motherboard main plug. Connect (use a bent paper clip) that green switch wire and any black wire. Plug in the power supply and it should run (fan starts)

Oct 26, 2009 | Gateway (ATX-300-12EB3) (ATX30012EB3)...

2 Answers

Hipro HP-d3057f3r computer power supply broken?


I have the same problem. I found this:

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=us&docname=bph06788&product=12455#bph06788_section_2

  • Replace the side panel, plug in the power cord, and examine the light on the back of the power supply:
  • If the LED is on solid and is not flashing, the power supply is probably good and the problem is most likely caused by a defective component (processor, memory, PCI card) or a defective motherboard. Have the computer serviced, or remove the components and replace them, one at a time, to find and replace the defective component.

  • Aug 16, 2009 | Hi-Pro Computers & Internet

    1 Answer

    No power


    An AT power supply must have current draw to turn on. Remove every component not needed for boot ( Floppy, Hard, CD DVD Fan. Leave on Motherboard and CPU and Fan. With header connections connected ( HDD led, PWR on, PWR Led and speaker ) push the on switch and make sure the back of supply doesn't have a switch. Does anything happen? Write me back if you want and we'll try to get some juice out of the supply.

    Jun 28, 2009 | Computers & Internet

    2 Answers

    ATX Bestec 1956F Power Supply Failure


    sounds like your power supplie has not been switched on by *********** board.the fan will not turn on until power supplie is turned on by mb.as far as what is wrong there are several things i can think of.i would try resetting bios. It sounds like your power supplie is working and your motherboard could have a short.but i have no way to be sure without testing. I can however tell you how to perform a test on your power supplie.unplug the 20 or 24 pin connector from your mb. look for a green wire,and then locate the grey one.short these two together(you can use a paper clip or something).if it dosnt power up. your power supplie is bad.also do not short any other wires,and only touch the grey and green for a few seconds as this is not how it was intended to be powered on.

    Mar 03, 2009 | Bestec ATX-1956F (ATX1956F) 200-Watt Power...

    1 Answer

    Psu shut down


    99% TIME IT IS A FAULTY FAN GOING OUT.

    REPLACING THE FAN INSIDE THE POWER SUPPLY WILL RESOLVE THE PROBLEM.

    P/S ARE CHEAP, JUST BUY A NEW ONE OOR REPLACE WITH ONE YOU HAVE ON HAND

    CANDYMANGANDY

    Jan 27, 2009 | Antec Solution SL400 Power Supply

    1 Answer

    ASUS Z91H PUSHED POWER BUTTON BUT WITHOUT DISPLAY


    Try pressing the power button and press [del] button. See if it goes to the bios setup page. If it does, have your harddisk checked. It could be corrupt OS or problem with your harddisk.

    Sep 12, 2008 | Computers & Internet

    2 Answers

    Mecer Notebook


    Your Battery is probably dead and can't hold any more charge as for the disc, its probably only made for the desktop computer

    Jul 21, 2008 | Computers & Internet

    1 Answer

    Broken Computer


    jkdhksjdfh

    sdlfds
    fdslkf;gjufe
    kg;drpgk
    efpkgek
    hk
    p

    Mar 13, 2008 | Computers & Internet

    1 Answer

    Pc no start.........


    You might have a bad power supply. If you have a voltmeter, check the voltage of the standby power supply. This voltage is present even if the system is off, plugged in. It powers a small portion of the logic circuit. It should measure within a couple of tenths of exactly +5 volts. If it is low, or high, this will prevent turn-on. The purple wire of the 24 pin connector is what carries this to the motherboard. The color coding layout is found at http://pinouts.ru/Power/atx_v2_pinout.shtml If by chance this voltage is OK, then check the full on voltages also. Repair of the defective supply is probably by replacement of one or more small electrolytic capacitors in the appropriate circuit, especially if you are technically savvy. Capacitors are available through several suppliers; Digi-Key supplyies Panasonic FC series which are suitable for switching power supplies. Or, you may just replace the whole unit.

    Apr 24, 2007 | HP and Compaq Pavilion Replacement 200w...

    Not finding what you are looking for?
    Computers & Internet Logo

    Related Topics:

    499 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Computers & Internet Experts

    Brian Sullivan
    Brian Sullivan

    Level 3 Expert

    27725 Answers

    kakima

    Level 3 Expert

    98816 Answers

    David Payne
    David Payne

    Level 3 Expert

    14071 Answers

    Are you a Computer and Internet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...