Question about Viking 24 in. Professional Series DFUD140 (Premium) Built-in Dishwasher

2 Answers

Dishwasher will not start

My Viking DFUD140 just stopped working. The control panel is still lit up, but the buttons for the various settings do not respond when pressed, including the start button. Has anyone seen this problem? Is there a way to reset the unit? Please help!

Posted by on

  • The REO Guy Dec 27, 2008

    all lights flashing, except start, pump running, cannot reset to initiate new cycle

  • amb760 May 06, 2014

    I have the same problem with the same dishwasher. Have reset and turned off breaker. Odd thing is that if it sits for about a week, it work. Does that give a clue. My guess is something has to dry out or electronics clear. Trying to assess if this 13 yr old dishwasher is worth fixing or should replace. Any advice appreciated!

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You can hold the start atop button down for 5 seconds to re set it or you can turn off the circuit breaker to the dishwasher for 20 sec. That should help. If not, it probably is a bad celenoid which a repairman needs to replace

Posted on Nov 19, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Sounds like you may have the "Child Safety" feature on. Power the dishwasher off then hold down the Normal Temp & Normal Dry at the same time while you power it on. Worth a try, hope it works!

Posted on Jan 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My viking 450E start button is not working - the cyle buttons light up blue and then the start button should start flashing so that you can press it to start but the start button never flashes - I have...


It's likely that the cheap POS start switch under the button has fallen off the cheesy plastic mounting and the button isn't contacting it. Put it back so the ears on switch are under the slots in the panel and dab a TINY bit of super glue where the tabs go into the panel.

www.appliancefixxa.com

Feb 02, 2012 | Viking VDB450 Dishwasher

1 Answer

Cycle control lights flashing all at same time


are you sure you have cleaned all the water outlets as when these get blocked and the water builds up the dishwash will go into a standby mode as a sefety precaution to stop your kitchen getting flooded if it was me i would take off all water outlet pipes and use boiling water and a good cleaning fluid it only takes a little blockage and then it will cut off so clean all pipes through properly and then try again is the water going into the dish washer before it cuts off or is their no water going into it either if you post back ill have a nother look for you hope this is some help i had same prob with mine but it was different brand of washer but after cleaning all pipes inlet and outlet it worked fine and is still working now use good limescale remover cause if you live in hard water area then this is probably you problem .......................................................

Nov 10, 2007 | Viking 24 in. Professional Series DFUD140...

1 Answer

Motor keeps running and we can't operate the dishwasher


Look for water accumulating under the dishwasher. It has a tray that will catch any leaking water before it gets to your floor. If this is the case the most likely cause for the leak is the drain hose (located behind the main pump housing).

Jan 12, 2011 | Viking 24 in. Professional Series DFUD140...

1 Answer

Miele g892 and just like everyone the red light comes on and dishwasher stops running> why cant you answer thic common problem>


The red light tell you there is a fault. You have to read the fault code and it will give you a general idea of the problem - to do this you have to enter the service mode of operation - close the door and turn the dishwasher on.
The Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should now be blinking.

Press and hold the Start/Stop button while turning the dishwasher on. Release the
Start/Stop button and immediately press it 2 more times. Flashing Intake/Drain and
Salt lamps and a lit Rinse lamp indicates successful accessing of services mode
Fault codes
F00 Pots & Pans Lit
F01 Sani Wash Lit
F02 Normal Plus Lit
F03 Normal Lit
F04 Economy Lit
F05 Rinse & Hold Lit
F06 Pots & Pans Lit
F07 Sani Wash Lit
F08 Normal Plus Lit
F09 Normal Lit Flashing

Sep 19, 2009 | Miele G880 Dishwasher

2 Answers

No water, sounds normal . might be silenoid switch on inlet valve? vud140 viking dw


could be the water valve silenoid connection clip to the power source has been disconnected, 2) water valve is clogged with debris, 3) water valve silenoid has gone bad. I think one of these three things may be your problem. Good Luck

Dave

Aug 07, 2009 | Viking Designer Series DFUD140...

3 Answers

Viking Designer Series DFUD041 Built-in Dishwasher


Did you try the power on button all the way to the left?

Jan 27, 2009 | Viking Designer Series DFUD041 (Premium)...

1 Answer

Condensation


Turns out the vent was obstructed. Re-positioned the custom-fit door and problem solved.

Sep 30, 2008 | Viking 24 in. Professional Series DFUD140...

1 Answer

No power


Hi lushman001

I'm Harvey the Master Plunber.

Your question is: your 3-yr-old dishwasher (Whirlpool 24-inch ) stopped in mid-cycle. A small amount standing water in the bottom of the washer. None of the control panel buttons were lit up and none of them will work. NO POWER

First check all the breakers (or fuses).
Second check the electrical connections. If you're not a qualified electrician or service tech then call one. It"s under the unit behind the kickplate.

Feel free contact me again!
Please give me a rating here at fixya.com before you sign off
Thank you,
Harvey your Master Plumber

Sep 11, 2008 | Whirlpool 24 in. DU1100XTP Built-in...

Not finding what you are looking for?
Viking 24 in. Professional Series DFUD140 (Premium) Built-in Dishwasher Logo

621 people viewed this question

Ask a Question

Usually answered in minutes!

Top Viking Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Starnley Johnwells
Starnley Johnwells

Level 3 Expert

1029 Answers

Gere knutson

Level 3 Expert

842 Answers

Are you a Viking Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...