Question about Kohler Santa Rosa K-3323-0 White Compact Elongated Toilet with Toilet Seat

2 Answers

Tank will not refill after you flush

When I flush the toliet the tank empties but will not refill. I can remove the lid to the tank and pull up on the float and it will begin to fill back up like it is suppose to. However, when I flush the toliet again it will do the same thing. What should I do?

Posted by on

  • Anonymous Dec 21, 2008

    I have a similar problem with the tank not filling after flushing, but I have float cup type system. And I tried to manual move the cup up and down and still no water flows into the tank. It is freezing outside and my home was built in 2004 with no exposed plumbing on the outside. Could the pipe to the toilet be frozen so no water is getting into the 2nd story toilet? All the other plumbing in the house works. Can you help me?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

The toliet tank won't refill after flushing. it has been freezing outside could the water pipe to the tank be frozen if so how could i fix this problem

Posted on Jan 16, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 43 Answers

Okay depending on the type of toilet ball **** (i know its a funny word, but it's really what its called.) you have one the most standard type is the long wire with the big ball on the end. you need to adjust this ball **** so it goes lower test it out, flush your toilett and wait till the water drains then when its supposed to come back up push down on the ball **** and youll see the water will start to fill, so then adjust the little screw on the fill valve (the other side of the floater where its attached)

you may need to shut off your water supply and drain your tank depending on how skilled you are,

pretty simple work, if you have questions feel free to ask.

Posted on Nov 16, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hymer 544. How do I stop the flush from running continuously?


After the tank empties, the flapper must drop into the tank outlet and seal it to prevent leakage as the tank refills. Otherwise, the tank empties as rapidly as it refills. The flapper could be defective or the linkage may require adjustment.

Aug 17, 2015 | Home

1 Answer

Winterizing


I think you have covered it all. Just last flush !

Jun 24, 2013 | American Standard AMERICAN STD 12 RGH...

1 Answer

After flushing the toliet continues to run. flapper will not automatically go down


Replace it and see if fixes it. The flapper is designed so that it stays afloat until all the water empties from the tank, then gravity takes over and closes the hole up and thus fills up. If you have a ballcock then the flapper may get trapped underneath when you flush it.

Feb 27, 2013 | Home

1 Answer

I have a Jacuzzi low flow toliet. Sometimes the water won't shut off after it is flushed


A frequent cause of this is a defective flapper. If the flapper does not seat properly after a flush, the refill water will flow continuously

Feb 19, 2013 | Home

1 Answer

After flushing the tank and bowl both refil properly. After about 20 minutes the water in the bowl has decreased about 1-2 inches. The tank is still full. Not sure what the cause and/or fix is


Vent pipe may need cleaning out, vent stops up your system has to get air to work so it will take it from where it can get it and the toilet maybe the easied place.
You may have a vent pipe that may be partly blocked or clogged up. To check a vent pipe out you can have someone fill a sink or tub up to the flood level rim and plug the drain. Have them remove the stopper and watch the toliet you have had issues wit to see any water movement. Once you deteemine which one is the cause you can snake the vent pipe or run a water hose down the vent and turn it on to flush out the vent pipe.

Hope this will help you out.

Mar 24, 2011 | Toto Carlyle 1-piece Elongated Bowl Toilet

1 Answer

Toilet model 386 is spraying water through the top of the water valve when tank is refilling.The water then is coming out between the lid and the tank onto the floor. email Address: milemc@yahoo.ca


there is a black hose line that goes from the flush valve to the fill valve. that black hose needs to be attached to the fill valve the one in the center. Your clip may have broken or it could of just slipped out. the hose is called the refill tube. If its broke then you will have to replace the flush valve.
moz-screenshot.pngtooldiva.jpg

Mar 14, 2011 | Summit Appliances Division Mansfield 386...

1 Answer

I have a single flush toliet and I am getting a poor flush.Toliet is 2 years old and was mad in 2006


Adjust the float height to allow mor water into the tank before it shuts the valve

Jan 22, 2011 | Kohler Home

1 Answer

My dual flush toilet fills up slowly how do i fix


Lift the tank lid off, place it somewhere safe for a moment, and look at what happens: If you're talking about jiggling the handle to get the tank to start to fill with water, then it sounds like the chain or rope is out of adjustment. It can't be TOO TIGHT or the water will leak past your flapper (will cause your dripping noise, tank water level will leak down, causing constant refills), and it cant be TOO LOOSE or the toilet won't flush correctly. Since you didn't mention trouble flushing the toilet, I think that it may be a little too TIGHT. When you jiggle the flush lever-it is supposed to pull a chain or cable to open the flapper at the bottom of the tank. Flush the tank and watch what happens-all the way through to refilling the tank with water and shutting off the water refill valve-Does the flapper get stuck on the chain or something? It is supposed to fall back down to allow the tank to refill after flushing out your toilet. Does the chain look very loose? The dripping sound you described indicates that the flapper is not sealing 100%. The flapper is very easy to replace, you just have to get the adjustment set for when you flush the toilet how sensitive you need it. You amy have to play with it a little bit before you get the adjustment correct.

Hope this helps!

Nov 08, 2009 | Home

1 Answer

I have a Eljer 150-403 and the toliet will not flush, although the handle is able to be moved down


Hi,

Remove the tank lid and set it aside. Inside, you should see where tha handle passes into the tank. There should be an arm running along the inside of the tank that raises when the handle is pushed down. Attached to the end of the arm is a chain that goes down into the water and attaches to the flapper valve. Now that you have identified all of these parts, push down on the toilet flush valve, and you should be able to identify where the toilet is broken. It is most likely he flapper or the chain.
Shut the water off behind the toilet, at the wall. Slowly stick your hand into the tank, and raise the flapper. (Don't worry, this is clean water).
Let the water drain through the toilet, and make your repair. All oarts necessary are available at any hardware store. Take your old part with you.
Best regards, --W/D--

Aug 11, 2009 | Home

3 Answers

Push Button - Have to Hold Down Button


I had the same problem. The fix cost me 50 cents (literally). I just placed a quarter on top of the Blue and White flush buttons (not sure of the technical terms) inside the tank and now it flushes properly. It seems that the 2 plastic poles the extend from the faux chrome buttons are just a bit too short.
Hope this helps

Feb 18, 2009 | Toto Aquia II Dual Flush Toilet

Not finding what you are looking for?
Kohler Santa Rosa K-3323-0 White Compact Elongated Toilet with Toilet Seat Logo

2,137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kohler Home Experts

john h

Level 3 Expert

7409 Answers

Tim Whalen

Level 3 Expert

3069 Answers

Mike

Level 3 Expert

4332 Answers

Are you a Kohler Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...