Question about Candy AQ130 Front Load Washer

1 Answer

Hot wash programme won't work.

I have a Candy AQ1300 washer dryer. Works fine except for the 90 degree wash programme (1)which just doesn't initiate. Light comes on but nothing happens - no water, no spinning, no nothing. Can anyone help with what might be causing this? All the other wash cycles work fine.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert who has answered 200 questions.

  • Expert
  • 244 Answers
Re: Hot wash programme won't work.

More than likely that your timer dial has a fault on it to replace your timer dial is alot if u need the 90 degree wash then you really are better off buying a new washer just as cheap to do it this way sorry for the bad news theres nothing you can really do sorry yet again m8

Posted on Aug 14, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Candy Washer/dryer Stalls

Have you checked the drain hose connection? Make sure the bung is clear in the trap

Aug 07, 2012 | Candy CNW136 Front Load Washer/Dryer

3 Answers

Problem with Brandt WBD1211 Washer/Dryer program 2


Jan 07, 2010 | Washing Machines

1 Answer

My Candy GrandO washing machine is boil washing

sounds like overheating, don't use until you have had it checked, may be dangerous

Sep 29, 2009 | Candy CNW136 Front Load Washer/Dryer

2 Answers

Zanussi ZWD1261 works fine except doesn,t turn off at end.

There is an issue with the timer . Needs to be replaced if it worries you.

Sep 20, 2009 | Zanussi WJS1265W Front Load Washer/Dryer

1 Answer

I just had my washer-dryer repaired by CandyHoover. They replaced the tub and drum. I put it through the half hour cycle yesterday, then today I put a couple pairs of jeans in it on the 40C cotton

hi i had the same problem clean the door seal then use some disilled malt vinegar on a 90 wash then clean your filter out then use some bleach with your washing powder on 90 wash clean your filter then you should be all good then as that worked for me

May 23, 2009 | Candy CNW136 Front Load Washer/Dryer

1 Answer

Programmes in washing mashine Eurotech FL 807 are really long (very old washer?) I want to run an empty mashine on 90 degrees (C) to clean it, can I combine hot water with a shorter programme although the...

yes - there is no thermostat to tell it the water is warm - go for it.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Jan 20, 2009 | Washing Machines

1 Answer

Maytag performa washer hot water runs continuously

Littleone.. please check your instructions.. some washers now dont need Hot water connection to them...they heat their own as part of the efficiency settings on the wash programmes themselves!

Regards Faggly

Mar 19, 2008 | Whirlpool Estate TAWS750PQ 27-Inch Washer

1 Answer

Dryer not heating up

I just had Sears Kenmore come out to my house because dryer drum turned, but did not heat up. It was a circuit breaker. My dryer has two voltages, 110 for the drum and 220 for the heater. It was 110.00 for me to learn to press the circuit breaker. I hope this helps you. Karen

Dec 17, 2006 | Candy AQW130 Front Load Washer / Dryer

1 Answer

Programme 1

make sure both solenoids have a working supply (if two fitted) at rear.

Nov 15, 2006 | Candy DQW150 Front Load Washer / Dryer

Not finding what you are looking for?
Candy AQ130 Front Load Washer Logo

Related Topics:

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Candy Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers


Level 3 Expert

57295 Answers

Are you a Candy Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides