Question about Ryobi Multi-Volt Battery Charger

2 Answers

Ryobi battery charger

When the dead battery is inserted in charger, green light comes on showing fully charged, instead of red.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

The same thing happend to my charger, i let it cool down and now the green light goes off and shows red again. thanx for that post

Posted on Mar 22, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Either the battery is hot from use or has been in the sun, let it cool down, then try again.

Posted on Jan 22, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chargers green light goes off as soon as inserted in boards 3 pin connector and not charging. seems dead.


Hi testing battery voltage will not give an accurate reading on battery condition U need a BATTERY LOAD TESTER.it will check the condition & give U a true reading on there condition ,..if batteries r good the next thing to check is the control box the charger circuit runs into the control then to the batteries if control box is faulty this could b the problem .,with youre charger not charging . LOAD TESTER AVAILABLE ON E/BAY APROX COST $35 , Cheers
26286345-jomi3yt0hmi0ynq23whfakpj-4-0.jpg

Sep 19, 2016 | Blue Health & Beauty

1 Answer

18v 12 cordless trimmer/edger. Why won't it start?


the trimmers switch may be faulty.

CHARGING THE BATTERY PACK
Battery packs for this tool are shipped in a low charge condition
to prevent possible problems. Therefore, you should
charge them until the green LED on the front of the charger
comes on.
NOTE: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged.
CHARGING A COOL BATTERY PACK
See Figure 3.
If battery pack is within normal temperature range, the red
LED on charger will come on.
NOTE: If the charger does not charge the battery pack
under normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorized Service Center for
electrical check.
n Charge the battery pack only with the charger provided.
n Make sure the power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
n Connect the charger to the power supply.
n Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger.
n Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
n Normally the red LED on charger will come on. This
indicates the charger is in fast charging mode.
n Red LED should remain on for approximately 1 hour
then the green LED will come on. Green LED on
indicates battery pack is fully charged and charger is
in maintenance charge mode.
NOTE: The green LED will remain on until the
battery pack is removed from the charger or charger is
disconnected from the power supply.
n If both yellow and green LEDs come on, this indicates
a deeply discharged or defective battery pack.
Allow the battery pack to remain in the charger for 15
to 30 minutes. When the battery pack reaches normal
voltage range, the red LED should come on. If the
red LED does not come on after 30 minutes, this may
indicate a defective battery pack and should be
replaced.
n After normal usage, a minimum of 1 hour of charging time
is required to fully recharge battery pack.
n The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
n Do not place the charger and battery pack in an area of
extreme heat or cold. They will work best at normal room
temperature.
NOTE: The charger and battery pack should be placed
in a location where the temperature is more than 50°F
but less than 100°F.
n When batteries become fully charged, unplug the
charger from power supply and remove the battery
pack.
Source(s):http://toolboyworld.com/eBay/Ryobi_P110/...

Jan 23, 2016 | Ryobi Garden

1 Answer

My nokia bh503 headset not charging


Leave it plugged in for 4 hours. Yello should turn red then green when fully charged

Oct 20, 2014 | Nokia Bh-503 Bh503 Bluetooth Stereo...

1 Answer

When plugged into charger both lights show green but chair not fully charged


First measure the voltage of the batteries at the charging socket of the joystick.

Sep 28, 2014 | Pride Jazzy Select Elite

1 Answer

My new 18v lithium batteries run out of charge after about 10 mins of continuous use is this about roght as my old Nicad batteries would go for about 20 mins this is using them with a drill driver with a...


This is not right. They should last much longer then that. I have one of the more expensive 18V lithium batteries (the one with the button on it that tells you if it needs charging or not) and I can use mine almost all day before it needs to be recharged. I do construction work and I use my Ryobi products almost all day. Either both batteries are bad (I don't believe that is the case) or the charger is not charging them all the way to a full charge. With this charger, you do need to make sure that you remove the batteries as soon as the green light comes on. It is not good on these batteries to stay charging after they are fully charged. You also should not leave the charger plugged in without any batteries charging.Please tell me more about the charger. When you plug in the charger, does the red light come on? When you plug in a battery, does the red light stay bright and the green light blink? Does the red light go off and the green light stay on bright when you remove it from the charger?
If the charger is not working correctly, then return it for a new one.

Nov 26, 2010 | Ryobi Two 18V Lithium-Ion Batteries +...

1 Answer

When I put the 18V battery in the charger, the green and yellow lights come on and stay on, instead of the red. What's up?


i always thoiught that when you light is green it is fully charges yellow is weak and red is dead
maybe you have it reversed check it again also make sure that (altho hard to do) the battery is in right

Mar 08, 2010 | Ryobi 15" Electric Factory Reconditioned...

1 Answer

Green and red light comes on when i put battery in charger what does that mean?


Here is the manual:
http://toolboyworld.com/eBay/Ryobi_P120/P120_566_eng.pdf

Red = quick charge
yellow = evaluating
green = charged

CHARGING A COOL BATTERY PACK
If battery pack is within normal temperature range, the red LED on charger will come on.

Red LED should remain on for approximately 1 hour then the green LED will come on. Green LED on indicates battery pack is fully charged and charger is in maintenance charge mode.

Feb 14, 2010 | Ryobi Multi-Volt Battery Charger

1 Answer

Green & Yellow light on 14.4V charger


It sounds like your battery is bad.

If both yellow and green LEDs come on, this indicates
a deeply discharged or defective battery pack.
Allow the battery pack to remain in the charger for 15
to 30 minutes. When the battery pack reaches normal
voltage range, the red LED should come on. If the
red LED does not come on after 30 minutes, this may
indicate a defective battery pack and should be
replaced.
n After normal usage, a minimum of 1 hour of charging time
is required to fully recharge battery pack.

Nov 24, 2009 | Ryobi Multi-Volt Battery Charger

1 Answer

What does the charge plus+ light and the green light mean together


If both yellow and green LEDs come on, this indicates
a deeply discharged or defective battery pack.
Allow the battery pack to remain in the charger for 15
to 30 minutes. When the battery pack reaches normal
voltage range, the red LED should come on. If the
red LED does not come on after 30 minutes, this may
indicate a defective battery pack and should be
replaced.
n After normal usage, a minimum of 1 hour of charging time
is required to fully recharge battery pack.

Jul 11, 2009 | Ryobi Multi-Volt Battery Charger

2 Answers

Ryobi lithium batteries won't take charge


For others with the same problem (flashing red light won't go off)...make sure you FIRMLY PUSH the battery down onto the charger and engage the latches. Simply resting the battery on the charger will not work.

Jan 30, 2009 | Ryobi 3-piece 18V Drill / Circular Saw /...

Not finding what you are looking for?
Ryobi Multi-Volt Battery Charger Logo

434 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ryobi Drills Experts

JOHN LAPIER

Level 3 Expert

2419 Answers

Cindy Wells

Level 3 Expert

4921 Answers

yadayada
yadayada

Level 3 Expert

69199 Answers

Are you a Ryobi Drill Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...