Question about Hitachi 46BX01B 46" Rear Projection Television

1 Answer

Hitachi 46ex3bc well here the problem when u push the power u can hear it click on but there no sound or picture..there i little red light flashing beside the power botton..and can hear a low clicking noise on the board not far from the main power supply..any idea what it might be..

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same problem with mine. i,m pretty sure that it is the built in surge protector is bad. Try unplugging the tv for 30 seconds then plug it back in and turn it on. If your surge protector has not completely gone bad this might work a few times. mine won't turn on at all anymore.

Posted on Dec 10, 2006


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Picture is black. sound went out a few weeks ago and now all that seems to work is the red power lamp turns on and I hear a click but that's all. I am not concerned about the picture since it is c

The click is a power relay on the main board and if the red light is on I would suggest looking inside to see if it has more than one relay--follow the power cord into the set----some of these sets have one relay but others have up to 3.

They are know for sticking open or shut. A tap on them can free them..A look inside even by a novice may also reveal something burnt or unplugged etc.
12_5_2012_3_12_13_pm.jpgview of relay bottom side is up.

Dec 05, 2012 | Hitachi 53SDX01B 53" Rear Projection...

1 Answer

Hitachi 42" ultravision...power light on, hear

Tries pushes the power switch on the remote few times,each times push wait like a 1 mins or 2 mins for the tv Tuner signal board to take it effect.This process should get ur tv picture back,because the tv Tuner signal board it is old and having problems,evenually require replacement of a refurbish tv Tuner signal board.Tries websites like, to buy a whole refurbish tv Tuner signal board for the replacement.

May 23, 2011 | Hitachi UltraVision 42HDS52 42 in....

1 Answer

Sony kdf-37h1000. push power button and the green lite comes on steady and i can hear a fan. never gets to a picture or sound. it then sounds like it shuts power off but lite goes from flashing green to...

Hi catfishbob,
You're lamp came to its peak burning life and now its dead that's why you can't power up the unit and the led light keeps flashing. Once the lamp replace with new one your unit will back to normal again. Click this link for the replacement
Hope I helped you.
Have a nice day!
Thanks for using Fixya.

Mar 05, 2011 | Sony KDF-37H1000 37" HDTV

1 Answer

No sound/picture and red power light always on (Hitachi 43FDX15B)

When u turn the tv on,u hear alot of clicking?That mean the Ballast that help the projection bulb to work is dead.Change the Ballast,might as well change the bulb too.U don't know what is the condition of the projection bulb in.

May 29, 2010 | Hitachi 43FDX15B 43" Rear Projection...

1 Answer

Hitachi 53uwx10ba turns on & off when off red flashing light/clic

Same problem. Replaced both convergence ICs about 5 months ago. Worked fince since then and just recently no sound, no video, blinking red on front panel and clicking sound. I suspect that the ICs went bad again and blew a resistor or two. I used cheap Chinese ICs instead of the Sanyo ones and thing this is why. I'll be looking at it again and post solution.

Jan 21, 2009 | Hitachi 50SBX78B 50" Rear Projection...

1 Answer

Standby/timer light stays on red. no picture or sound on tv.

my sony red light flash.but it will not turn on just clicks

Nov 26, 2008 | Sony KP-48S75 48" Rear Projection...

1 Answer

No picture or sound

Remove the rear panel. With the TV on you should see a red LED near the center of the PCB. There should also be 5 green leds, 3 to the left a 2 behind. If there is no red leds, check the fuses. If there are no green leds or maybe 1 or 2, disconect PSD5. It's a connector on the left side of the power board that connects to the audio board. It's the 3rd on fro the back. It's labled. With that disconected, turn on the set and look for the green leds. If all 5 light, the power supply is OK and you have a problem beyond that. If they don't all light you have a bad power supply.

Jul 21, 2008 | Hitachi 50EX20B 50" Rear Projection...

1 Answer

Hitachi 43F300 43 in. Rear... Problem:

units in shut down to protect further damage,poss. power supply or deflection fault

Jul 21, 2008 | Hitachi 43F300 43" Rear Projection...

Not finding what you are looking for?
Hitachi 46BX01B 46" Rear Projection Television Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Televison & Video Experts

Jaime Hernandez

Level 3 Expert

2326 Answers

The Knight
The Knight

Level 3 Expert

75025 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Hitachi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides