Question about Oasis P1AQ

2 Answers

Oasis water cooler taps started dripping

It started dripping a few weeks ago but if you wiggle the tap handle around a bit it will stop dripping temporarily until you use it again. is it a washer or do i have to purchase a new tap or taps?( there is a cold water & a room temp. tap) is this a "do it yourself" project or is it to difficult task to try to fix on my own? thanks for any advice you can give me

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

If the cooler is a hot and cold, even if its a cook and cold, the cooler always needs to be cleaned and maintained, not only on the inside but on the outside, as the cooler is used calcium builds up over time. that is why your taps are leaking, there is a build up in the taps, therefor the taps are not sealing properly and letting some water thru. i say take the taps out and clean them with vinegar.
the second thing u can do is the taps do come apart into smaller peices once u disconnect them from the cooler. take the taps apart and find the spring located within it, stretch the spring and than reconnect the peices together than reconnect to the water cooler.

Posted on Jun 09, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Just had this problem... hot was fine, cold was leaking. the rubber stopper was kinda nasty and needed to be washed, and there was a little bit of plastic residue that had made its way in between the seal and the rubber which was wicking water through drip by drip... a good cleaning... (more fun when there is a full tank on it at the time) and it's good as new, no more drip :)

Posted on Nov 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vaillant boiler leaking only when heating switched off.


It would seem a joint has come a bit loose from the heating and cooling cycle. put a drip pan under the leaking area( the drips would evaporate quickly), then next time you shut it down go through all the joints in the area with wrenches to find the loose joint.

Oct 27, 2014 | Water Heaters

1 Answer

1996 chevy 3500 7.4 vortec. the ecm fuse blows at the turn of a key


One of the power wire going from your ecm to a sensor or solenoid is shorting to ground. Get a wiring diagram and an ohm meter. disconnect the battery and start checking each wire measuring from the wire to ground. as you wiggle you will see the meter show 0 ohms when it is shorted. These are the hardest and most time consuming kind of electrical problems .good luck

Nov 21, 2011 | Cars & Trucks

1 Answer

Lisbon monobloc kitchen taps just installed the


Put some cooking oil around the o-rings to sofen them up so they would seat around all fitting surfaces. Hope this helps.

Aug 12, 2010 | Home

1 Answer

I bought the compressor about two years ago and used it only a few times. It ran fine a few weeks ago but today it will not start. It is as though it is not plugged in even though the outlet works for...


Is it possible that you didn't drain the air out of it after you used it a couple of weeks ago? If the pressure in the tank is somewhere around 100psi, the compressor won't run until it drops lower. If there is no pressure in the tank you might see if you can wiggle the pressure lever that makes the switch move to turn on the motor - it might be stuck.

Aug 04, 2010 | Air Tools & Compressors

3 Answers

Rocket 3 wont start. dials dead


Lift the tank. Underneath it you'll find a plastic connector block joining loads of wires together. Turn the ignition on and push this connector block together, or twist it around a bit. If the ignition sequence starts, it'll be because the wires in the connector block are corroded. Moving the block sometimes makes a temporary fix, but ultimately it'll happen again until the block or the wiring harness ideally, is replaced.

May 07, 2010 | 2007 Triumph Rocket III

1 Answer

Rear window wiper works for a few days or weeks


Check the plug is completely plugged into the motor. Maybe a bad connection in the motor itself. Also check the switch, try wiggling it when turning on.

Mar 06, 2010 | 2003 Oldsmobile Silhouette

1 Answer

406 wont lock/unlock please help!!!


Switch ignition ON.Press and hold lock button for 10 sec.Switch ign.Off.Remove key from ign. switch.Wait 5 sec.Sinchronization procedure complete.Confirm sinchronization has been successful by locking,double locking and unlocking vehicle. Repeat abuve procedure to sinchronize any remaining key.Good luck

Nov 30, 2009 | 2005 Peugeot 405

1 Answer

Panasonic Mixer/Blender not working - works only when tapped


It looks like there may be some loose wire connection. Or it may be due to carbon brush probelm. We at Inno Concepts or any of our dealers can diagnose and fix the problem for a reasonable cost. Please contact us at 770-594-1815 or send us an email with all the details to info@innoconcepts.com

For grinding hard vegetables, use thinner pieces not more than 1/2" in any dimension.

Jun 23, 2009 | Food Mixers

Not finding what you are looking for?
Oasis P1AQ Logo

1,621 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oasis Refrigerators Experts

Charles T Nevin
Charles T Nevin

Level 3 Expert

4070 Answers

John Tripp
John Tripp

Level 3 Expert

4655 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

Are you an Oasis Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...