Question about Nintendo Guitar Hero Wireless Guitar - Wii for Wii

1 Answer

Wont power up, blue lights stay on have changed out the batteries

Have changed out batteries numerous times, cheap, good and rechargeable batteries.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Try resetting the remote and the console. in the console you open front panel and their is a red reset button press this firmly then remove batteries from back of remote press the reset on the console again. Then replace the batteries press the red reset on the console a third time and then push the red reset button on the back of the wii remote this should take care jof your problem.

Posted on Jan 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My wii balance baord wont switch on, its had two lots of brand new batteries & a recharge plug in box from Argos. It appears to be charging (green light at the back of the recharge adapter) but then as...


Balance Board will only power on if balance board compatible game is running on the Wii and you may to recalibrate again. Also, try it with disposable batteries.

Apr 29, 2011 | Nintendo Video Game Accessories

2 Answers

My x31 turtle beaches were working just fine yesterday, but today they're not turning fully on and working alltogether. Every time I turn them on there's this high light to low light flash, then they...


You just need to change your batteries. If you're using rechargeable batteries, it's likely that they've reached the end of their functional charge cycles and need replacement.

Feb 23, 2011 | Voyetra Turtle Beach Wireless Headset...

1 Answer

Blue light on, battery won't charge, unit new 12/14/09


rechargeable batteries are definitely a better bet. I have used many Wii battery packs and chargers, none seem to last very long.

Jun 05, 2010 | Nyko Wii Fit Battery Pak for Nintendo Wii

2 Answers

I have a wii fit board, when you power it up, it


Had the same problem. It's a sync problem.
First, best to double check you have fresh batteries.
Next, turn the board upside down and remove the cover from the battery compartment.
Open the small hatch cover on the front of your console unit.
Now start wii fit from the disk menu item.
Next, press the small red button inside the balance board battery compartment. The blue lights will blink for approx 3=5 sec.
While they are blinking, press the red button on the console (in the hatch compartment).
This should re-sync your board and the light stays lit.
Good luck.

Apr 07, 2010 | Nintendo CTA Digital WI-BBP Wii Fit...

1 Answer

Bought 2nd hand wii fit, have just loaded disc and replaced batteries in board but power light not staying on board, flashes for about 30 seconds and then switches off. Does it need to be synchronised with...


    Hope this helps

    Try these steps!

  1. Insert a Wii Balance Board compatible game disc in the Wii console.

  2. Use the Wii Remote to select the Disc Channel from the Wii Menu, then select "Start" to begin the game. Press the A Button to bypass the wrist strap screen.

  3. Open the small SD Card slot cover on the front of the Wii console.
  4. Remove the Battery Cover on the bottom of the Wii Balance Board.
  5. Press and release the SYNC button on the Wii Balance Board. The blue light on the board will start blinking.
  6. Press and release the red SYNC button on the Wii console while the blue light on the board is still blinking.
  7. The blue light will stop blinking and stay on steady once the synchronization is complete.
please leave a good rating and testimonial if you appreciate my help. THNX

Mar 27, 2010 | Nintendo Wii Fit for Wii

1 Answer

Wii balance board power light does not stay on,screen says push power button w/ your foot i do and a blue blinks a few times and the screen stays the same


You need to Sync it first.Open the SD Card slot cover on the front of the Wii console, just below the disc drive, then push the red button there, then open the batteries cover on your Wii Fit and push the red button there.

Nov 09, 2009 | Nintendo Wii Fit for Wii

1 Answer

Wii fit balance board


Make sure that whatever game you are playing (ie: Wii Fit) is fully loaded before pressing the power button.

If the light continues to go off, you may need to re-sync your Wii Fit balance board to the console. To do this, load Wii Fit, and when the program is running, press the red button inside the battery cover. Immediately press the same type of red button inside the panel on the Wii located between the eject and reset buttons (on the face).

If these steps don't work, try fresh new alkaline batteries and repeat.

Note that there have been lots of complaints using rechargable batteries. I've had the same alkalines in my unit for 3 months now. If insistent on using rechargables, I suggest buying several of the same battery and a quick (15 minute or 1 hr) charger as opposed to ANY after-market recharging product. It will be cheaper and more reliable.

Good luck!

Apr 07, 2009 | Nintendo Wii Fit for Wii

1 Answer

Cant charge battery pack for wii fit balance board


You may want to send an email to customer.services@gem.co.uk. In the meantime, try keeping it plugged into the USB port for at least an hour, or perhaps overnight. See if the light stops flashing and stays on. Then try plugging it back into the Wii Fit unit.

My personal suggestion is to return the charger and battery and buy a 15-minute charger and four more NiMH AA batteries than you need for all of your accessories. Not only are AA batteries compatible with all your accessories, but you won't be out a gizmo while it's needing to be charged.

Good luck!

Jan 27, 2009 | Nintendo Rechargeable Battery Pack 3600mAH...

3 Answers

Power


    Try these steps!

  1. Insert a Wii Balance Board compatible game disc in the Wii console.

  2. Use the Wii Remote to select the Disc Channel from the Wii Menu, then select "Start" to begin the game. Press the A Button to bypass the wrist strap screen.

  3. Open the small SD Card slot cover on the front of the Wii console.
  4. Remove the Battery Cover on the bottom of the Wii Balance Board.
  5. Press and release the SYNC button on the Wii Balance Board. The blue light on the board will start blinking.
  6. Press and release the red SYNC button on the Wii console while the blue light on the board is still blinking.
  7. The blue light will stop blinking and stay on steady once the syncronization is complete.

Sep 09, 2008 | Nintendo Wii Fit for Wii

Not finding what you are looking for?
Nintendo Guitar Hero Wireless Guitar - Wii for Wii Logo

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nintendo Video Game Accessories Experts

pwetherhill

Level 2 Expert

44 Answers

yadayada
yadayada

Level 3 Expert

61129 Answers

Josh Whitehead
Josh Whitehead

Level 3 Expert

1146 Answers

Are you a Nintendo Video Game Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...