Question about Sony KP-53S65 53" Rear Projection Television

2 Answers

TV won't show any picture or color

We were watching a show and heard a loud pop and smelled a burned elect. component then the screen acted up and the Tv turned off on its own. I could not turn it on anymore, i hear it click like its turning on and a red light near the power button comes on but theres no picture or color what so ever. if its left on like that for a while, a heavy burnt smell is detected. does anyone know what might be the problem and what i can do to fix it?

Posted by on

  • aries jamirez Dec 06, 2006

    Guru, i tried counting the blinks from the light near the power switch but its countless i counted up to 100 times and it didnt pause, it just kept on going and like i said a heavy burned smell is detected when left plug in with the ligth blingking thank you again and hope you can give me more help or any body out there can help will be appreciated thank you Guru.

  • aries jamirez Dec 06, 2006

    Again the trouble from my TV is this when you try to turn the TV on you hear clicks like normal but no screan or sound and light(timer/stand by) will blink continusly. heavy burned smell is detected when leftmore than 2 minutes.

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 65 Answers

There are a lot of pico fuses is this tv the smell you probaly smelled was the flyback replace it replace the stk packs too while your at it

Posted on Dec 09, 2006

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 119 Answers

1St. need to konw how many times the light bilks, it sould bilk a # of times then a short pause then repeat the # of bilnks again & again. The number of blinks is a an error code to help locate the cause of a fault. it is not allways accurate, but it's usually right. give the # of bliks & i will try to get you into the right circuit.

Posted on Dec 05, 2006

  • kevin letteney Dec 06, 2006

    well if the bilnks have no pattern it will make it harder, since you hear a pop & had a smell the best thing is to start loking in the tv for a blown part. I would start by looking at the power/voltage reg. board. typicaal the "G" board in a sony. look it over well. once you find the blown part try & get the location # of the part. Isuspect it's propablly a transistor or a capacitor. transistors will start with a "Q" for a location caps start with a "C". if you find a blon cap the top will be bubbled or swolen. ( the top will be rounded instead of flat.) if its a transistor it could have blown off the fron of the part, easier to find or could have made a minor crak, alot harder to locate. lastly, if you can smell it getting hot, it may help you isolate where the bad parts are.
    good luck.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to diagnose my led tv issues


You most likely had a capacitor let go, they make a pop when the go out, inspect the PCB for a burned mark.

Oct 12, 2016 | Toshiba Televison & Video

1 Answer

Had a loud snap when watching then no power.


TV repair, clicking and will not power on, loud snap, no ...

? 13:57
https://www.youtube.com/watch?v=UKoR7pWAHzk
Nov 25, 2014 - Uploaded by Robert DIY
TV Power board replacement - 30 - 60 minutes ($20 / $110 / $250 / Replacement) This video will show you ...

Samsung LCD 46 Pop! Then Dead! - TV Forums

www.tv-forums.com/...Repair.../Samsung_LCD_46_Pop!_Then_Dead!_...

Nov 23, 2011 - 7 posts - ‎3 authors
While watching TV, I heard a loud pop, then the tv went dead. ... Ok, so I tested the fuses and the main fuse, by the power plug, had no ...

Samsung power defect causes some TVs to fail, and a class ...

www.cnet.com > Home Entertainment

CNETFeb 14, 2012 - A defective capacitor in some Samsung LCD, plasma and DLP TVs is causing the ... The LN-S4051D is one of the TVs Samsung admits has issues ... In a February 9 report entitled "More than 7 million Samsung TVs plagued by possiblepower defect", ..... Today I heard a loud pop and now I have no picture.

Feb 09, 2016 | Samsung Televison & Video

1 Answer

I have a flat screen TV. I heard a loud pop and now I have no picture or sound.


check the power supply board which may have burned component parts.

Oct 07, 2012 | Emerson Televison & Video

1 Answer

I was watching my Hitachi 42hdm12 and heard a pop and now the picture won't show up or sound or anything?


A pop is usually a power surge and you blew a board. If you take the tv apart, if this is it, it will be evident by the burn marks. You could have burned out the internal power supply as well.

Oct 04, 2012 | Hitachi P50H401 50 in. Plasma HDTV

1 Answer

Have a 65inch Mitsubishi DLP. acouple years old, just heard a loud pop,smelled like it was burning,it turns on but just sound????


hi,
Check the lamp of you tv. The lam is burned. that's why you heared a pop up sound and burning smell. Just check it and replace it. you will get the picture back.
ok

Apr 16, 2011 | Mitsubishi WD65737 65" DLP TV

1 Answer

Is it possible to replace the bulb in this tv or something like that? I was watching it the other day when a loud pop occurred and there was some burning smell accompanied by the picture and sound going...


Shop around for the Big Screen repair Tech. Shop.The problems u discribing,the tv have more than a dead projection bulb.Circuits boards have burn components,must be trouble shoot and replace first.Before even know the static of the projection bulb.

Jul 16, 2010 | Sony KP-53S65 53" Rear Projection...

1 Answer

No picture. no sound


Bulb may have popped. Cheapest fix, unless your an electrician it the only thing to really try before replacing set.

May 31, 2010 | Sony Grand WEGA KDF-60WF655 60" Rear...

1 Answer

No Picture, Power light Blinking 3 times then repeats


3 times blink shows lamp cover is removed or not installed properly on TV.
Please take out lamp inside TV and check, seems its broken as you heard loud pop.
Thanks.

Aug 28, 2009 | Sony Grand WEGA KDF-55WF655 36" Rear...

1 Answer

Samsung DLPTV bad picture and buzzing sound


You color wheel blew a bearing. You need to replace the color wheel.

Mar 28, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

3 loud pops and picture faded away


ours was off all day and it pop 2 times and now no picture at all.

Jun 01, 2008 | Zenith Z50PX2D 50 in. Plasma HDTV

Not finding what you are looking for?
Sony KP-53S65 53" Rear Projection Television Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75169 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...