Question about Datamax DMX-I-4212 Label Printer
I keep getting the same error message, top of form fault. This causes the printing job to stop after only a few stickers. Any Ideas
You need to calibrate the printer using the instructions located in the manual. This should be in area 5.2 of the manual. If you don't have the manual you can download them at this address along with software updates and firmware updates.
Hope this helps you.
Posted on Nov 22, 2008
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
turn off then on
A critical firmware error has occurred that
caused the processor on the formatter to
abort operation. This type of error can be
caused by invalid print commands, corrupt
data, or invalid operations. In some cases,
electrical noise in the cable can corrupt
data during transmission to the printer.
Other causes include poor-quality parallel
cables, poor-connections, or home-grown
programs. On rare occasions, the formatter
is at fault, which is usually indicated by a 79
1. Turn the printer off then on.
2. Press Stop to clear the print job from
the printer memory.
3. Turn the printer off then on.
4. Try printing a job from a different
software program. If the job prints, go
back to the first program and try
printing a different file. If the message
displays only with a certain software
program or print job, contact the
software vendor for assistance.
5. If the message persists with different
software programs and print jobs,
disconnect all of the cables to the
printer that connect it to the network or
6. Turn the printer off.
7. Remove all memory DIMMs or thirdparty
DIMMs from the printer. (Do not
remove the firmware DIMM.)
8. Remove all EIO devices from the
9. Turn the printer on.
10. If the error no longer exists, install
each DIMM and EIO device one at a
time, making sure to turn the printer
off and on again as you install each
11. Replace a DIMM or EIO device if you
determine that it causes the error.
Aug 08, 2011 | HP LaserJet 4700 Printer
Mar 28, 2011 | HP LaserJet CM1015 All-In-One Printer
Jan 28, 2011 | Dymo LabelWriter 400 Thermal Printer
Apr 26, 2010 | HP LaserJet 4700 Printer
Dec 16, 2009 | HP LaserJet 4700 Printer
Dec 18, 2008 | HP LaserJet 5200tn Printer
Apr 14, 2008 | Konica Minolta Magicolor 2530 DL Laser...
Mar 15, 2008 | HP LaserJet 4350 Printer
Jan 09, 2008 | IBM 6400 Matrix Printer
9,567 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: