Question about Belkin (F6C800-UNV-PL) UPS System

1 Answer

The monitor goes into power save mode and the ups disconnect

I have installed a Belkin F6C1000 TW-RK to a new Vista 64 system and it appears that when the monitor goes into power save then the USB connection is disconnected.

I downloaded the latest software from your site to support the UPS.

Can I set the Windows power mangement on monitor, hard disks and system standby to Never to solve this problem?

Thanks,

Rick Craig

Posted by on

  • rcraig Nov 20, 2008

    posted by rcraig on Nov 13, 2008
    Report abuse

    I have installed a Belkin F6C1000 TW-RK to a new Vista 64 system and it appears that when the monitor goes into power save then the USB connection is disconnected.

    I downloaded the latest software from your site to support the UPS.

    Can I set the Windows power mangement on monitor, hard disks and system standby to Never to solve this problem?

    Thanks,

    Rick Craig
    Still need a solution for this problem? Try our Premium Assistance plan


    Best Solution
    posted on Nov 13, 2008





    jonathan_m_h

    Rank: Wiz
    Rating: 75%, 11 votes


    It should work, make sure each profile is set the same way. Keep in mind you should still be able to utilize your standby feature, and your screensaver as well.

    Question - I set both battery and power options to never but the screensaver doesn't come on. Any suggestions.

    Thanks,

    Rick

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 49 Answers

It should work, make sure each profile is set the same way. Keep in mind you should still be able to utilize your standby feature, and your screensaver as well.

Posted on Nov 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

F6C1250-TW-RK This unit worked for 5 min after a powerout, before it shut off.


Please check after removing the panel to see if the battery voltage is down or gone below the threshold limit and so the UPS has shut off.
Also if the battery connection is bad the load will not be supported. Clean and reset the connections. If not the UPS board has a fault and might need careful checking.

Jun 30, 2011 | Belkin (F6C1250-TW-RK) (F6C1250TWRK) UPS...

1 Answer

F6C1000TWRK will not start. Replaced batteries. Clicks when it is plugged in. Is it worth fixing?


For the price it will take to get it fixed, you can buy a brand new one. But if it is less then three years old, belkin will fix it for free.

Mar 02, 2011 | Belkin (F6C1000-TW-RK) (F6C1000TWRK) UPS...

1 Answer

Belkin F6C1500-TW-RK discharged new batteries, won't recharge


This sounds like a battery issue...I would have the unit and batteries tested at your nearest batteriesplus store... www.batteriesplus.com

May 07, 2010 | Belkin (F6C1500-TW-RK) (F6C1500TWRK) UPS...

1 Answer

Belkin F6C1500 UPS will not run on batteries


I think your issue is that the unit is overloaded. Try this...unplug a couple of items to get the load lower...then pull the plug from the wall...did it keep those few units running while disconnected...if not then the unit could still be overloaded...unplug everything but a small electric radio...do the same thing to see if it will keep the radio playing. If this doesnt work, go by your nearest batteriesplus store and they can help. www.batteriesplus.com

May 04, 2010 | Belkin (F6C1500-TW-RK) (F6C1500TWRK) UPS...

1 Answer

My BELKIN F6C1000-TW-RK just quit working, I guess I need new batteries as I bought it in 2005? Which batteries and where can I get them?


remove the battery. It will have a number on it also the voltage and amp hrs. You can find the battery online or if you have an interstate battery store near by they will have what you need.

Dec 05, 2009 | Belkin UPS Battery Finder: UPS F6C800UNV...

1 Answer

Battery connection.


Here's the manual with battery replacement instructions. If not detailed enough, give their support line a call.

http://cache-www.belkin.com/support/dl/f6c1500-tw-rk.pdf

Toll Free from USA: 1 800 2BELKIN

May 29, 2009 | Belkin F6C1250-TW-RK 1250VA TOWER RACK UPS...

1 Answer

Monitor goes to power save mode on startup


Sounds like a bad video card (if embeded "built in") then you need a new mother board

Dec 09, 2008 | Belkin (F6C800-UNV-PL) UPS System

1 Answer

Ups repair


First Larn some English (rofl) Then try replacing the batteries,

Oct 11, 2008 | Belkin (F6C1500-TW-RK) (F6C1500TWRK) UPS...

2 Answers

Belkin ups not working properly.... green and RED light on ...indicates bad battery. But unit not more than 1 yr old, no battery time at all when plug pulled...not enen i min on (desk to an d monitor


Your batteries are weak...(causes
1:-not powering the UPS for a longtime
2:- long use(3 to 4 years) )...you will have to replace them
PLEASE RATE ME.................

May 25, 2008 | Belkin (F6C1500-TW-RK) (F6C1500TWRK) UPS...

Not finding what you are looking for?
Belkin (F6C800-UNV-PL) UPS System Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Belkin UPS Battery Backup Systems Experts

John
John

Level 2 Expert

473 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

cwradio73

Level 3 Expert

899 Answers

Are you a Belkin UPS Battery Backup System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...