- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The date and time (and a lot more) are stored with every picture in its EXIF metadata. Any photo viewing/editing program should be able to display this data. To print this data, please consult the documentation for whatever program you're using to print your pictures. Depending on the program and printer you may print the date on the image, in the margins, or on the back.
try and reset your printer,unplug the power cord and wait 10 min, then plug back in,understand that Canon has installed a chip so you cannot use refilled cartridges,or cartridges you refill,if this doesn't work,then contact Canon,and you could get the same message I got take it in to be repaired, (to costly), so I end up buying a new one,,
The date/time setting process may be slightly different on different camera. Which camera do you have ? Nevertheless, you first need to set the date/time on your camera. And when you print, say using PictBridge, you need to set the DPOF date setting at WITH DATE. And you need to use a printer that supports date printing.
Press the power button to turn off the printer. Hold down the transfer and left arrow button at the same time. While holding them down at the same time turn on the power button. Let it go through the initialization process and once completed, the head should be in the up position. Open the cartridge door and push the cartridge to make sure it is latched and locked in place. Once the cartridge is latched, release the latch and the cartridge should release itself. Remove the cartridge from the printer.
I found a how to video on the web.Turn off your printer. Hold down the left arrow button and transfer button at the same time, then turn your printer back on. You should hear it make some noises, open side door push on cartridge to see that it is locked in. Then hit the green release button on the inside and the cartridge should come out on its own.
Here's the manual for the G600. http://www.kodak.com/global/en/service/publications/urg00536toc.jhtml Loading paper is listed under "Getting Started". Remember to load the paper logo side down. Hope this helps.
The thermal print head mechanism is probably jammed (It is the only large heavy metal piece inside the unit). To check, unplug all cords, remove two screws on back of unit, and then carefully lift top off unit. Unplug two ribbon cables that connect the top to the circuit board inside the unit (pull straight out on the circuit board end of the cables). You will see a metal shaft running across the width of the unit, approximately in the center front to back. This shaft drives the print head via a plastic lever on one end and a plastic sector gear on the other end. The sector gear is hidden under the circuit board. Depending on if the teeth of the sector gear are engaged, you should be able to rotate the shaft a fraction of a turn (1/8 to 1/4). If you need access to the sector gear, remove the circuit board by unplugging two more ribbon cables from the circuit board, and 3 screws holding the circuit board to the metal frame. Lift the circuit board and fan/fan-holder straight up as one piece, being careful not to stress the fan wires. Make sure the round metal bosses on the sides of the print head frame are under the plastic lever and sector gear. If this is O.K., check for freedom of gear movement by turning the large gear near the stepper motor in the rear corner of the unit. It should turn easily by pushing the teeth with a small screwdriver. The print head frame should move when the gear is turned.