Turns over - wont start

Did you check for ignition? Spark? Ignition coil? ECU?

My guess is that after it ran out of gas, the key was in the forward position for a while and you unknowingly interrupted the antitheft system. Try to reset it.

RELEARN PROCEDURE:
Turn the key on, with the engine OFF.
Try to start the engine, then release the key to ON, Engine will not start.
Watch the security telltale, after about 10 mins, it will turn OFF.
Turn OFF the ignition, and wait 5 seconds.
Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. You must turn the ignition OFF for 30 seconds before attempting to start the vehicle after the 3 cycles. Then start the engine .


Do It Yourself GM Security bypass

Chevy 2500HD No Start No Spark No Fuel Cranks OK
Testing !!!

You will need to figure out if you have spark to the plugs, and if not- if you have voltage to the coil to proceed.

Tyhe first thing you shd always do on any car with starting problems is to check the spark on the plugs to localize the problem to either fuel or ignition problem. If u have an old spark plug lying around, remove one spark plug wire and attach it to the plug and lay it against the block. If it fires, when the engine turns, then it will most likely be fuel problem.
If it turns out to be fuel problem, you can prove it by using starting fluid carefully into the breather area.

If you need further help, reach me via phone at https://www.6ya.com/expert/gary_9c859f4aa7e5ab10

Hi, Ok you have confirmed that it's not a fuel problem. You need to check for spark. Pull the coil wire off of the coil(secondary lead-looks like a spark plug wire) Have some one crank it over and listen for a popping sound. IF yes, spark is at the coil, that means all ignition sensors are working. Next check for spark at ends of wires after cap. IF no replace cap and rotor. IF yes remove a couple spark plugs and check for fouling(wet, fuel etc...) IF yes replace or clean plugs and retest for starting. IF no spark is present at coil you need to scan computer and watch for rpm signal. IF no rpm signal, replace crankshaft sensor with OEM delco part. BIGGEST problem with these engines is Cap and Rotor burn out.

What size engine? Sounds like crank sensor or ignition module.

replace the ignition module,under the coil pack.

1 Inspect Battery Battery Discharged or Faulty. 2 Inspect Battery Cable Corroded, Broken, Shorted or Poorly Connected Battery Cable. 3 Inspect Fuel Filter Clogged or Dirty Fuel Filter. 3 Inspect Distributor Cap Distributor Cap Cracked or Burned. 5 Inspect Coil - Ignition Faulty Ignition Coil. 6 Inspect Wireset Worn, Damaged or Faulty Spark Plug Wire(s). 7 Inspect Spark Plug Incorrectly Gapped or Fouled Spark Plug(s). 8 Inspect Starter Starter Motor Faulty. 9 Inspect Fuel Pump Low Fuel Pressure. 10 Inspect Solenoid Switch Faulty Starter Solenoid Switch. 11 Inspect Relay - Fuel Pumpat Faulty Fuel Pump Relay. 12 Inspect Fuel Injector Pressure Regulator Faulty Fuel Injector Pressure Regulator. 13 Inspect Ignition Switch Improperly Connected or Faulty Ignition Switch. 14 Inspect Starter Drive Faulty Starter Drive. 15 Inspect Fuel Injector Dirty or Worn Fuel Injectors. 16 Inspect Fuel Pump Strainer Clogged or Dirty Fuel Pump Strainerat. 17 Inspect Engine Control Computer Incorrect Operating Information Being Delivered and Sent From The EEC. 18 Inspect Fuel Tank Fuel Tank Empty. 19 Inspect Carburetor Carburetor Flooded or Faulty Choke. 20 Inspect Distributor Worn, Loose, or Incorrectly Installed Distributor.

timing belt broke most likley