Sun Roof Motor is not closing the Sun Roof

You must dismount the sunroof glass, and then run the open an close operation until the cables are lined up. You will know when. Then install the glass back. Hopefully the plastic track is not broken.

For sunroof related problem,if your exact car model is provided,then it will be better.But in this case,i suggest you to check the link below:----How to Remove Power Sunroof on Acura Integra? http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-power-sunroof-on-acura.html
------------How to manually close Sunroof on 2000 Lincoln Navigator? http://technoanswers.blogspot.com/2012/01/how-to-manually-close-sunroof-on-2000.html
-----------No power to Courtesy Lights and sunroof? http://technoanswers.blogspot.com/2012/01/no-power-to-courtesy-lights-and-sunroof.html
-----------This will help.Thanks.

1. 1. Tilt the moon roof into the vent position as much as possible and press on the front portion of the control.
   
2. 2. Now release the switch.
   
3. 3. Now press and hold that same switch again for 30 seconds or until the moon roof begins to move.
   
4. 4. Now release the switch ans immediately press and hold the switch agaon.
   
5. 5. Now the moon roof should close then open then close again.
   
6. 6. You MUST wait until the moon roof has closed that second time before releasing the switch of the process will be a failure and you will have to start again.
   

• Here is the manual for you too. http://www.motorcraftservice.com/pubs/content/~WO4FOC/~MUS~LEN/40/04focog2e.pdf
  

• Hope this helps.
  

caution if it opens you may not be able to close it again, this sounds like the track broke or something in the motor. lets hope its the motor as if its the track then the whole track needs to be replaced, there is no repairing a broken sunroof track.

I have built oem sunroofs for 20 years and if it was jerking to close you may have something in the track interfearing with the closing, but more than likely there is something broke. There is alot of plastic parts. No over-ride on an oem roof. The only obstacle in a motor replacement is make sure your lifter arms (the parts that the glass attaches to) are in the closed positon. This is called timing. You can help the motor along with a light pull or push to take some strain of the motor.

Try checking the fuse first, it could be that simple. Some times there's is a place to manually crank it closed, that's covered up by piece of small trim on your headliner usually before the sunroof opening or after. Good Luck

hit the switch again while you have someone feel the relays under the dash in the fuse panel.... the one that is clicking needs to be replaced... your sunroof should be fine after that.

check fuse F1.401, 30 amp in central junction box (in truck). Check your owner manual for fuse information.
Headliner must be removed to access motor.



Visual Inspection Chart Mechanical Electrical

• Roof opening panel
• Roof opening panel frame
• Roof opening panel drain hoses
• Roof opening panel lifter assemblies
• Roof opening panel water trough
• Roof opening panel air deflector assembly
• Roof opening panel seal
• Roof opening panel shield

• Battery junction box (BJB) fuse
• Circuitry
• Accessory delay relay
• Roof opening panel switch

• The roof opening panel does not open or close

• Roof opening panel adjustment.
• Battery junction box (BJB) fuse.
• Circuitry.
• Roof opening panel switch.
• Roof opening panel motor assembly.
• Roof opening panel lifter assemblies.

• The roof opening panel does not open or close — one direction only

• Circuitry.
• Roof opening panel switch.
• Roof opening panel motor assembly.

It needs to be ovehauled. This is a mere mechanical fault.

you dont have a manual crank in the overhead of your car there should be a plastic cap in the middle of the overhead. pop it off and it requires an allen wrench

hope this helps