Question about Sony PFM-42B1 42 in. HD-Ready Plasma Television

Open Question

SONY PMF-42B1E RED LIGHT BINK SIX TIME

When I swich on my sony pfm-42b1i cam on for cople second then go off then cam on and off red light star to flash six time. thank you for your help

Posted by on

6 Suggested Answers

  • 1 Answer

SOURCE: KDF-E60A20 Red Light Flashing 6x

My TV KDF-E60A20 is now Fixed. My tv was overheated and Thermal Fuse Located bottom of the lamp burned. I replaced a different Thermal fuse part from 191000644 to 191002393
at www.partstore.com
search for part number. thank you for the review it's help me a lot
thank again

Posted on Nov 27, 2007

  • 20 Answers

SOURCE: sony PFM-42B1E plazma screen

Does the red standby light flash ?? If so count the flashes and see my error code section.

Posted on Aug 25, 2008

  • 20 Answers

SOURCE: PFM-42b1 Manual

I have the full service manual - shaundolphin@yahoo.co.uk

Posted on Sep 06, 2008

  • 1 Answer

SOURCE: PFM-42b1e LEd flashing 6 times... 1 sec. picture with green stripes... and then it turned to standby

I have a sony tv PFM-42B1 when I turn it on it go to standby an a red light flash I count count 14 time but I heard that it only support to flash 1 to 6 time how do count the flash

Posted on Dec 25, 2008

  • 1 Answer

SOURCE: KDF-E60A20 Red Light Flashing 6x

a 6x blinking error code is usually the thermal fuse located above the lamp housing on the light engine. probable cause of failure is clogged fan located in same area or poor ventilation because set is to close to wall [unit requires minimum of 4 inches of clearance]. part # is 1-910-023-93. another possibility but less likely is the gm board which drives the lamp voltage. part # is a1109407a.

Posted on Jul 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Sony PFM-42B1E, I switch it on and it powers up for a couple of seconds with a flash of snow on the screen then power light flashes 3 times, I opened it up and disconnected the ribbon power cable...


ok,..if originally u were having some image problems of a snow like flash on the screen,..then i would advice u to replace that DMD board,..the board u disconnected the ribbon power cable from.

Apr 02, 2010 | Sony PFM-42B1 42 in. HD-Ready Plasma...

Tip

SONY PFM-42B1E FLASHING ERROR CODES


Ok i have here the problems that occur when the red standby led flashes on these sets which is an error code.

2 FLASHES ( PAUSE ) 2 FLASHES = X SUS TEMP (DD CON)

3 FLASHES ( PAUSE ) 3 FLASHES = Y SUS TEMP (I/O BLOCK)

4 FLASHES ( PAUSE ) 4 FLASHES = CENTRE TEMP

5 FLASHES ( PAUSE ) 5 FLASHES = DIGITAL 5VOLT

6 FLASHES ( PAUSE ) 6 FLASHES = PDP PANEL FAULTY

I hope that helps you cheers.

on Nov 11, 2007 | Sony PFM-42B1 42 in. HD-Ready Plasma...

1 Answer

I have a sony pfm-42b1 plasma tv with 2 vga inputs an 1svideo input.. i want to connect my ps3 hdmi cable to the vga input. i purchased the cable but nothing shows.. thanks for your help


you should change it from hdmi to cable. You can do it only on a hdmi tv when you do that you can use it for the pfm-42b1e because i had the same problem too. when you plug your ps3 to a hdmi tv you go to settings-display settings- video output settings than you change it to av multi. After you do that you can use it on pfm-42b1e

Dec 16, 2008 | Sony PFM-42B1 42 in. HD-Ready Plasma...

1 Answer

Sony PFM-42B1E plazma screen


Does the red standby light flash ?? If so count the flashes and see my error code section.

Jul 05, 2008 | Sony PFM-42B1 42 in. HD-Ready Plasma...

1 Answer

PFM-42b1e LEd flashing 6 times... 1 sec. picture with green stripes... and then it turned to standby


I have a sony tv PFM-42B1 when I turn it on it go to standby an a red light flash I count count 14 time but I heard that it only support to flash 1 to 6 time how do count the flash

May 06, 2008 | Sony PFM-42B1 42 in. HD-Ready Plasma...

1 Answer

DVD Connection to sony flat panel


hi there mate i have a sony plasma pfm42x1 i being trying 2 conect my dvd and amp to the tele i dont know what plugs i need could u help me please rodney from australia

Feb 18, 2008 | Sony PFM-42X1 Plasma TV

4 Answers

TV Flikers and StandBy Light Flickers


Your pdp panel sounds faulty - Count the red flashes this is an error code.

Nov 13, 2007 | Sony PFM-42B1 42 in. HD-Ready Plasma...

Not finding what you are looking for?
Sony PFM-42B1 42 in. HD-Ready Plasma Television Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Flat Panel Televisions Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Paul Bade

Level 3 Expert

1392 Answers

Are you a Sony Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...