Question about Desa International CBN30T Central Heating System Heater

1 Answer

HEATER GOING OUT

You can light it.It stays lit for one or two minute go out.

Posted by on

  • 1 more comment 
  • sullins6 Dec 31, 2008

    will not stay lit.

  • fatjackbob Jan 10, 2009

    It was the pilot light.I blew the vent hole out on the pilot and it works fine .

  • jimbo460 May 11, 2010

    what are u lighting that wont stay lit is it the pilot light?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 36 Answers

Thermocouple is collapsed,get a universal one,a lot cheaper

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New kozy world natural gas heater. Pilot light wont stay lit snd heater flame wont stay lit.


Are you holding down the pilot light button long enough for the heat sensor probe to get hot and turn on the gas valve? It takes up to 3 minutes

Nov 20, 2016 | World Heaters

1 Answer

I have a nexgrill propane patio heater the pilot light works but when i turn it to lo or high after a minute or so the pilot light stays on but the burner wont light


Propane Patio Heater Troubleshooting - YouTube

? 6:54
www.youtube.com/watch?v=BqYIWuDUZOUDec 12, 2008 - Uploaded by PatioShoppers Great tips about troubleshooting your outdoor patio heater. ...Pilot Light Won't Stay Lit - How to Replace a Broken Thermo Couple on Furnace ...

May 12, 2014 | Williams 2509612 Ceramic Mid-Size Heater

1 Answer

When I press down and turn the know the pilot lights but as soon as you let up on the knob to turn it there is a click and the pilot light goes out.. This is on my Mr. Heater Big Buddy


When the pilot lights continue holding the button down for a full minute and then release. It should stay lit then to allow you to turn it to the on position. If the pilot will not stay lit after holding it for the full minute, then the thermocouple will need to be replaced.
Hope this helps.

Sep 16, 2011 | Mr. Heater Big Buddy Heater

1 Answer

Reddy Heater will not stay lit


Thermocouple it going bad had same problem, you Should replace it.

Jan 03, 2010 | Reddy Portable Forced Air Propane Heater...

1 Answer

My mr heater mh9b won't stay lit. The pilot flame starts acting wierd and making noise after ten to fifteen minutes of being lit and then goes out completely. It can be re-lit but goes out again in a...


my mr heater mh9b won't stay lit. The pilot flame starts acting wierd and making noise after ten to fifteen minutes of being lit and then goes out completely. It can be re-lit but goes out again in a bit. Any suggestions?

Nov 17, 2009 | Mr. Heater MH9B Ceramic Utility

1 Answer

Torpedo heater wont stay lit.


Do you have the serial number or the manufacture date? There are some design changes and I would need to know the year of manufacture to assist accurately. Usually it is a relay or the thermocouple connection that will affect the unit staying lit.

Mar 29, 2009 | Reddy Portable Forced Air Propane Heater...

2 Answers

Infra red heaters wont stay lit flame in the tubes


have you tried to heat up thermal couple for a couple of minutes. It takes a few minutes for the flames to actually starts heating thermal couple you might have to move thermal couple a little closer to heater flames

Jan 16, 2009 | Reddy HD30 Heater

1 Answer

Pilot light won't stay lit on convection heater.


replace the therocouple. next year do not turn the pilot off

Nov 24, 2008 | Clairion Convection Heater - HC-1500

1 Answer

Wont stay lit


go to this site www dot desatech dot com. Here you'll find parts to repair your heater. a propane heater uses a millivolt generator to sense the flame. along it's cappilary are two push on spde connectors. these connect to the high limit temperature sensor which is mounted on the flame backplate of your heater. to see if it is the high limit shutting down your heater, jumper across the two spade connectors. if the heater stays on, this is your problem. if the flame still goes out, then the millivolt generator is shot.

Nov 09, 2007 | Coleman 5075751 Utility Heater

Not finding what you are looking for?
Desa International CBN30T Central Heating System Heater Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Desa International Heaters Experts

paulcarew

Level 3 Expert

1914 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Gil Shultz

Level 3 Expert

3250 Answers

Are you a Desa International Heater Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...