Question about Philips Magnavox 51MP392H Rear Projection Television
The model # is 51MP392H17. I bought it in March of 2005. It is a 51'
Fuses have been replaced but it still doesn't work.
Actually I have this TV and you need 2 Convergence IC's STK392-120's (120's and 150's will work) of course order 2 of the same type I'm using replacement 150's they allow for a little higher heat and were cheaper ALSO you need to replace the 12 resistors with 6.8 ohm metal film resistors, make sure they are metal film! don’t skimp out here I did and then they blew and fried my IC's and I had to replace everything again!
Great reference link that I posted pictures on, check out page 3
Where I got all my parts that worked:
Suburban Electronics http://www.suburban-elect.com/
Manual Library you should find all you need here:
What you need:
(2) STK392-120 OR STK392-150 IC chips
(12) 6.8 Ohm Metal Film resistors
set of star screw drivers
15 watt pencil solder pencil, DO NOT use a high watt iron you will fry the surface mounted item.
good leaded solder, and flux
BTW if you don’t plan on trying this and are going to throw out the TV, I still need a IC convergence board for a 51MP392H/17 TV I'm fixing, I'm willing to pay S/H and buy your IC board that’s not been tampered with. Edwinkraus@hotmail.com
Posted on Nov 20, 2008
Tips for a great answer:
Aug 24, 2011 | Philips Magnavox 51MP392H Rear Projection...
Aug 02, 2009 | Philips Magnavox 51MP392H Rear Projection...
Jun 17, 2009 | Philips Magnavox 9P6034C 60" Rear...
Jan 25, 2009 | Philips Magnavox 9P6034C 60" Rear...
Dec 18, 2008 | Philips Magnavox 51MP392H Rear Projection...
Sep 22, 2008 | Philips Magnavox 51MP392H Rear Projection...
Jan 02, 2008 | Philips Magnavox 51MP392H Rear Projection...
Nov 24, 2007 | Philips Magnavox 51MP392H Rear Projection...
136 people viewed this question
Usually answered in minutes!