Tv screen 48 inch color screen has drooping colors with double images

You need to replace your convergence ICs. Please see www.TvRepairKits.com. They have what you are looking for. If you feel you cannot do this repair yourself ask a TV tech. Show him this info, this is your best defense, you now have knowledge for a general repair. Hope you can get repairs at a good price. Thanks for asking and show a few hands of support!

Defective convergence ic's along with bias resistors. Estimated repair is 250-350 for a service company.

this is a rear projection tv not lcd the color is off because the convergance chips are bad take the board out that has the tow stand up chips attached to heatsinks out order the stk number search for on google then take a om meter check all the resistors aroung the chips replace them also you must be a excellent soilder person or a tech to install and remove these chips

You have defective Convergence IC's. It's best to have a service company verify and do the repair if you wish. Normally runs about $250.00

In all probability you need to have the convergence amplifiers replaced. A very common problem with all projection sets.

Assuming that your TV is a rear-projection TV, then it sounds like the separate red, green & blue tubes aren't set correctly.

Each tube needs to be alligned exactly to produce the image on the screen. If any of the 3 are mis-alligned then the effect you describe is caused.

Somewhere in the menu settings, will be an option to set the Convergence. This option will allow you to set the allignment of all three tubes.

Older sets do not have this option, and need to be adjusted via controls on the main PCB.

Hello:

Thanks for this forum.

I have a Toshiba 48" rear projection TV which started to show red and green lines on the left side of the screen and have also started affecting the left-hand focus of the image shown on the screen. I have had this TV for 14 years and had a projection adjustment done once before.

Thank you in advance for your assistance.

Ed Alexander

i hope this helps. on the tv, press menu, then channel up or down to "screen", then menu;
then channel up or down for adjust projection tv(6), then press menu;
then use the volume up and down, as well as the channel up and down until each of the 3 colors are lined up. press menu after each color i slined up to go to the next color.
hope this helps.

did you adjust the convergence
on the menu?

http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html

convergence amp ic bad