96 Dodge Runs fine but after warms up it dies,cools n will crank n run good then dies again after warming up.

Probably not.
I would check ther fuel supply/pump.

It is possible that the solenoid on the starter binds when the starter is hot. When you say that the starter was tested, was it tested hot?

Does the starter click when you attempt to start it? When you turn the key, the switch energises a small relay, which in turn energises the solenoid, which in turn applies power to the starter motor.
The solenoid should make an audible sound when it pulls in the plunger.

If you have a second person, one could turn the key, and another could gently hit the solenoid with a rubber or plastic hammer. This worked on a Dodge minivan that I had.

An image of the plunger is available at
http://www.amazon.com/Starter-Solenoid-Rebuild-Contacts-Intrepid/dp/B00COOB298

ONE OF THE COILS COULD BE GETTING HOT

if you dont know anything about cars then take it to a dealer as it will be cheaper in the long run

I don't know what testing you have done? When it stalls if it cranks good but won't start, have a helper crank it while you visually check for spark at the spark plugs, if spark everywhere, use a gage and check proper fuel pressure. Also, check fuel injector pulse. If your missing all three, I usually check the cam and crank sensors. There could be other issues? Any applicable trouble codes?

Did you find a fix?
Same problem, wondering how you fixed it?

2001 dodge ram 1500 dies after releasing accelerator.runs good while accelerator is depressed.

it sounds like the radiator is starting to get pluuged, i would pull it out and have it checked & cleaned, its an inexpensive place to start.

No, the coil the is not the problem. I would take the ignition module and have it tested. Even though it may not test bad b/c it is still cold, it is more than likely the problem. Have you checked to see if you are getting spark when the trouble occurs?

Yes the crank sensor can cause this problem, they go open when hot.