Squawking when I try to boot it up

post #3
why post 3 times, same squawk.?
go to your first post and read. please.

You have the 'squawk' turned up too far. This will be a standard dial or a small slotted dial inset in the body. Turn counter clockwise to lower the resonance effect. This should not be confused with a transponder squawk code, which is a different thing totally. If your model is more up to date then the squawk function will be automatic and toy will need to reset it by firstly switching the unit off, then hold the transmit button and the volume UP button while powering the unit on. This will reset all the functions of the unit back to the factory default. If you still have problems then the unit is faulty and needs repair or replacement.

blower is squawking due to bad bearings internally.. needs replaced.. as for cold air check fluid levels first.. then be looking into heater hoses and control valves..

your going to have to get under it to see if it is gummed up. Spray penetrating oil liberally on those connecting rods and try to move it. Remember,,,,no matter what your manual says or the dealer that squawks about 4 wheel on the fly... come to a stop, put it in neutral then shift in to 4 wheel.

other than check your wiring for rubbed spots or loose connections, I don't know. maybe try swapping parts one at time with your buddy. maybe your headset?

The idler bearing that keeps tension on the belt is going out due to heat leaching the grease out of it. Have it replaced.

It might be that when the speakers get warm after running for a while, component starts to breakdown and causes the noise. This will require a expert to check and fix

Or it could be a cable problem. Try wiggling the cables to the speakers and see if the squawking stops or changes. If so you could replace the cables.

if you have had the unit for a while the sweat may have corroded the speaker. see link....

http://ctorunner.googlepages.com/dismantleforerunner205

Lint around the bobbin case is very likely...if issue persists, take to service centre as damaged bobbin case may need replacing, or more serious damage from broken needle jam etc

Height control action noisy, emitting squawks when operating. Air in heigt control system. Bleed system.