- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
1.) Make sure the power cord is secured in the printer and the wall outlet confirmed working
2.) if no lights or antyhing on the screen after pushing the power button then unplug from wall and try again. If still nothing then it is a hardware issue and needs to be serviced at a service center.
Are you taking it off electricity a log? If so you have to set it up to your preferences sometimes. And are you tapping the "on" button at far left at the top? It should work. But it must be plugged in of course and the button has to be pushed. Don't push too hard or too long or it will turn off.
More than likely the Start button is faulty. Push it harder to see if this works, if so then the start button needs to be replaced. This is actually a common break down simply because that button is the most popular button on the control panel and it is the first to pack it in.
I downloaded the most recent firmware from dell (3.11T, A03) and reinstalled it. When you run the program, there's a radio button that says "printer" and one that says "network". I did the one that said "printer" and nothing happened. Then I ran the firmware update again and picked the one that said "network" and it started working shortly afterward.
I'm assuming that some component of firmware in the network card was messed up. I could still use the network printing but the "scan" button wasn't working. This fixed it for me. Your Mileage May Vary.
Try the resetting the printer to factory defaults.
1.Turn the Printer OFF, unplug the power cabled from the back of the printer and from the wall outlet.
2.Then, Press and hold the ON button for 30 -60 seconds
the Ink Cartridges out, Unplug the printer power cable while its ON,
press and hold CANCEL and COLOR COPY button and connect the Power cord
while holding the buttons.keep Holding the buttons until the printer
goes off ,release the button and Push the ON button.