Slow printing

Silly question maybe, but has the scanning or printing resolution changed?

Does it have an inksaver programme that has been switched off?

Not enough memory, add a harddrive or more memory.

This can sometimes be caused by a problem with the hard drive. The image data is stored on the hard drive prior to processing. The hard drive can be corrupted by repeatedly not powering-down in the correct manner. If the hard drive requires replacement then it has to be re-formatted and the system software re-installed. This can only be performed by a Canon engineer.

you check the memory at the copier cable print size

CHECK THE TONER --IF IT IS LOW REPLACE IT...THIS IS A COMMON PROBLEN ON A LOT OF PHOTOCOPIERS.

ithink memory check and remind

i removed the paper from feeder, by pooling out under the feeder, then start to print and printer starts and quickly stop and on top on display shows L1 ( blanking signal). non any bottons respond by pushing them.