Question about Malber P25 Front Load Washer
Big pulley on my 2 yr old malber has cracked and fallen apart. It appears to be made of soft pot metal. Machine has been lightly used by all-adult household. What would cause this? Belt tension? Cheesey manufacturing? Belt was in pristine condition...
They are cheap cheesey pullys. Yes they are the same as the eurotech units. What you wanted it to be made to last (heck not even maytag does that)
Posted on Jul 08, 2007
I'm not familiar with that particular brand, but it looks like a eurotech, and we sell those pulleys by the truckload. They are made of a similar material and break if you look at them funny. You may however, check that the inner tub does not move up and down if you reach inside the wash area and push up on the inner tub. If it does, you have bearing problems and are going to need some serious work, otherwise replace the pulley and it should be fine. Hope this helps!
Posted on Oct 21, 2006
Tips for a great answer:
Nov 14, 2013 | Malber WD2000 Front Load Washer / Dryer
Sep 12, 2011 | Kenmore 44102 Front Load Washer
One of the most common problems with washing machines, however, is that they won't spin. Usually this is caused by an issue that easily can be fixed, but other times it can be more serious. In some cases, just the balance of the load can cause the machine not to spin.
For that reposition the clothes. Close the lid and retry. The washer may not spin at all if the tub is unbalanced.
Check the lid switch for wear. Replace a worn lid switch by first using a screwdriver to remove the top of the machine. Remove the cabinet holding the old switch in place by unscrewing the two console screws, tilting the console back, removing cabinet clips, and unlocking the lid switch block. Unscrew the mounting screws, and disconnect the ground wires before removing the old switch. Insert the new switch in its place.
Then check for lose or worn or crack in belt. If these signs appear, remove the old belt by tipping the washing machine over on its side, and unscrew the clamps securing the pump coupling with a screwdriver. Place the new belt over the transmission pulley, and then over the motor pulley's nearest edge, slowly turning the motor pulley to pull the belt around and into the pulley.
Replace the washer's motor by firmly grasping on the metal slip-on connectors holding the wires in place, allowing you to pull the connectors apart. Use a screwdriver to unscrew all of the screws holding the motor in place, and remove the old motor. Insert the new motor in its place. Secure the new motor to the machine with screws, and reconnect the motor's wiring harness.
Replace the washer's pump by removing the service panel on the back of the machine with a screwdriver and disconnecting the washing machine drain line and the rubber pump outlet hose. Remove the fasteners holding the pump to the bottom of the machine, along with the drive belt from the pulley below the pump. Replace the old pump with a new one, and reinstall the drive belt back on the pulley, reinsert the fasteners and reconnect the rubber pump inlet and discharge lines.
So there are various conditions when a washing machine wont spin. Please check this link to get a detailed idea related to your problem:-
Please get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com
Aug 05, 2011 | LG WM1814CW Front Load Washer
Feb 09, 2011 | LG WFT1071TP Top Load Washer
May 04, 2010 | Malber WD1000 Front Load Washer/Dryer
Nov 28, 2009 | Creda W100FW Front Load Washer
Jan 25, 2009 | Malber P21 Front Load Washer
Apr 11, 2007 | KitchenAid KAWS850L Top Load Washer
88 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: