Question about Heating & Cooling

Open Question

Dyna-Glo LP heater 10 years old replacement parts??????

Hi and thank you for this site. This is awesome. I have a 10 year old Dyna-Glo RMC-40 LPT heater. I use this 4 months out of the year in a greenhouse. When I fired it up a week ago the burner flame is very yellow tipped with a baaaaaad smell. Pilot is straight and blue and the heater fires fine. It has been cleaned but that yellow flame is not right. Right? My guess is the burner needs replacement since it does show a little corrosion over the surface.......it is, after all, old and in a humid greenhouse. I've searched and Googled everything for hours and cannot find replacement parts. Any suggestions would be MOST appreciated as I am in Minnesota and it is getting COLD! Thanks!

Posted by on

  • Anonymous Dec 01, 2008

    I have the same problem (orange flames) but it is sporadic and I have no odor. Furthermore, my pilot light will not stay lit and to light it, I must hold down the knob until the pilot has been lit for about 2 minutes (otherwise it shuts right down again). I assume the heat sensor is broken (tells the unit the pilot is lit).

  • Anonymous Jan 18, 2009

    have propane heater from a old air stream works good but needs the material that glows on the front panel-was told this material could be found but I dont know where

×

5 Suggested Answers

TheMobilian
  • 8205 Answers

SOURCE: Dyna-Glo model RMC-8000PGH will not stay lit

Your pilot safety is full of dust. Flush it out with shop air or rust buster. Retry

BONUS INFO

Posted on Dec 17, 2009

  • 1 Answer

SOURCE: Have Dyna-Glo Unvented Gas-Fired Room Heater,

I had the same issue. Iwent to the local harware store and bought heay duty mirror hangers. They work great for only a few bucks.

Posted on Dec 09, 2009

  • 1 Answer

SOURCE: Have a Dyna Glo RMC-95-C2 and I can't get it to lite.

You have to change the batteries.. the manufacturer shipped it with **** batteries.

also take it apart.. very simple and clean out any soot..

Soot will cause heavy smoking...

The wick should last more than a year ....

Posted on Dec 23, 2009

boysor2933
  • 293 Answers

SOURCE: Replaced pilot sensor. Still not lighting furnace. Have a high humming sound for about 2 mins then nothing. Any suggestions? Furnace is about 8 years old

The humming sound might be a stuck blower motor or a motor that won't start due to defective starting capacitor.

Posted on Nov 06, 2012

emissionwiz
  • 70387 Answers

SOURCE: My 215 heater will fire up OK then sometimes after running for 20 minutes and sometimes a hour it will shut off pilot and all any ideas

Defective thermocouple or gas valve

Posted on Jan 08, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a dyna glo RMC 40 NGT vent less wall heater that I would like to convert to propane, I need to know which conversion kit to buy, and where. Thank you.


dyna glo natural gas heater Questions & Answers - Fixya

www.fixya.com > Forum > Tags
dyna glo ventless rmc50 ngt can this heater be changed from natural gas to propaneuse, ... Dyna Glo Natural Gas conversion to LP Gas I have a Dyna-Glo natural gas space ... Question about D-E36 Infra-Red Wall Mounted Panel Heater ... dyna glo heater model #RMC-40GT I believe on your particular model , that you ...

Parts for Dyna Glo, Thermoheat and Dyna Glo Pro Heaters

spaceheaterparts.com/category.sc?categoryId=13
Shop Dyna Glo, Thermoheat, Dura Heat, Workhorse LP and oil fired htrs ... Circuit Board 2201181 Dyna Glo & Thermoheat 150k Nat Gas Htr RMC-FA150NGDGD ... This spark plug (ignitor) is used on Dyna Glo and Thermoheat 40K btu LP.

Propane Wall Heaters - Walmart.com

www.walmart.com > ... > Heaters

WalmartDyna-Glo IR18NMDG-1 18,000 BTU Natural Gas - Infrared Vent Free Wall Heater. $170. ... Dyna-Glo 40K Liquid Propane 360-Degree Tank Top Heater. $88.00 ... Dyna-Glo Deluxe RMC-FA125DGD Portable Gas Powered Forced Air Heater.

1352062 Dyna Glo Natural Gas conversion to LP Gas

162.220.53.34/F/.../t1352062-dyna_glo_natural_gas_conversion_lp_gas

Jan 12, 2016 | Heating & Cooling

1 Answer

I need a thermocouple for a dyna glo heater model #RMC-40GT


I believe on your particular model , that you have to replace the entire pilot assembly. As the thermocouple is an intricate part of it. In which case any LP or Natural Gas heater's pilot assembly will fit it. You will have to secify either Natural Gas or LP Gas when ordering.

I have provided 2 links to where you can purchase the pilot assembly you need.

http://www.mrheater.com/OrderParts2.aspx?catid=57

http://www.aandbsales.com/index.html



I hope this helps you & thanks for choosing FixYa.

Jul 29, 2011 | Dyna-Glo D-E36 Infra-Red Wall Mounted...

1 Answer

Need a control knob for: dyna-glo pro propane heater. model: # rmc-tt30dgp-01, # rmc-tt30dg, # rmc-tt30gd. this is the off/low/med/hi temp. control knob.


I AM TRYING TO FIND A PROPANE REGULATOR FOR A DYNA-GLO PRO. THE MODEL # IS RMC-TT30DGP. THERE IS A NUMBER ON THE OLD REGULATOR. THAT # IS S2NTT0002-2.THANK YOU.

Dec 17, 2010 | Heating & Cooling

1 Answer

My Dyna glo Heater RMC-KFA210WH-03 will not fully ignite


I just bought one. The fuel line was cracked. Replaced it 2$ fix
10_13_2016_3_30_56_pm.jpg

Jan 27, 2010 | Dyna-Glo (PPH16-LP) Utility Heater

1 Answer

Dyna-Glo model RMC-8000PGH will not stay lit


Your pilot safety is full of dust. Flush it out with shop air or rust buster. Retry

BONUS INFO

Dec 17, 2009 | Dyna-Glo RMC-8001SS Heater

1 Answer

Have a Dyna Glo RMC-95-C2 and I can't get it to lite.


You have to change the batteries.. the manufacturer shipped it with **** batteries.

also take it apart.. very simple and clean out any soot..

Soot will cause heavy smoking...

The wick should last more than a year ....

Dec 14, 2009 | Dyna-Glo RMC-8001SS Heater

1 Answer

Have Dyna-Glo Unvented Gas-Fired Room Heater,


I had the same issue. Iwent to the local harware store and bought heay duty mirror hangers. They work great for only a few bucks.

Oct 22, 2009 | Dyna-Glo Heating & Cooling

1 Answer

Dyna-glo parts


thermocouples you can buy from any heating spares oulet or national energy a hone well is most common for useing as a replacement

Feb 03, 2009 | Dyna-Glo D-E36 Infra-Red Wall Mounted...

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

798 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

paulcarew

Level 3 Expert

2364 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Donni Steen

Level 3 Expert

659 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...