Question about Toshiba 34HF84 34" TV
Toshiba 34" is getting power. Can tell by the illuminated LED on the front of the TV. When I go to power it on it makes the sound like its going to come on.....that clicking noise that tv's make......but then nothing comes on the screen and about 10 seconds later it makes another ticking sound. The screen never powers on. -tried to switch plugs -tried to leave it unplugged for like a week......nothing -tried different remote (I had a universal and regular for it) -tried using the panel on the front of the TV in case it was a standby issue.....nothing
Most likly it is a problem in the power supply regulator circuit. pretty common for Toshiba TV sets. If you know about TV serviceing, first thing to replace would be the regulator IC as that is the problem 80% of the time. if that does not help then you will need a schematic to trace out the regulator circuit. Good Luck PS please dont forget to rate this thread.
Posted on Oct 19, 2006
The ticking sound could be high voltage breakdown, or noise from the line output transformer. The magnetic core material is a ceramic which is magneostrictive. This means, as the transformer core is magnetised by the coils of wire carrying current it changes size. This causes sound to be radiated. If you can hear 15KHz coming from the television, then the line timebase is working. If all you hear is a ticking sound, then most probably the circuit has a fault, such as a faulty line output transformer. If you have a good TV which ticks, it probably has a bad earth connection to the tube, or some arcing, and must be put right as this could cause a fault to occur.
Posted on Oct 22, 2006
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: intermittant remote
yes they do go bad. try cleaning the inside of the remote and check for a bad solder connection with-in the remote. the key pad can get dirty from your handling maybe a good cleaning but do not scrub it just lightly touch the pad with cue tip and alcohol
Posted on Mar 20, 2007
Demo is activated / de-activated by holding a combination of
two buttons on the tv front for at least four seconds. Try menu &
power or vol up & chan up...........T.
Please rate this solution.......
Posted on Nov 12, 2007
SOURCE: Toshiba 32A32 won't turn on
just fixed one with that problem it was the vertical output ic Q301
that was shorted. try wicking it out. it is a LA7833S.
Postings say to be sure to use the Toshiba part
Posted on Aug 28, 2008
Tips for a great answer:
Dec 01, 2014 | Toshiba Televison & Video
Dec 12, 2013 | Mitsubishi WD-62526 Projection TV
Dec 01, 2012 | Toshiba Satellite L355-S7811 Notebook
Oct 31, 2012 | Sanyo DP42849 42 in. HDTV
Mitsubishi TV troubleshooting
Here's something that might also be useful. After you turn on the set, and get the regular red blinky lights, hold down the Device and Menu buttons together for about 5 seconds.
The Power light will start to flash in a two digit sequence.
For example, 3 flashes, then 7 flashes = 37.
Here are the error codes, and the corresponding problem:
12 = No error detected, check power supply.
32 = Lamp Cover is open.
33 = Air filter cover is open.
34 = Lamp abnormality
36 = Light Engine (DMD or Lamp Fan stopped)
37 = Exhaust or Lamp Ballast Fan stopped
38 = Lamp Temperature High
39 = DMD Temperature High
41 = Short is detected
44 = DVI cable between FMT and Engine disconnected
Jul 17, 2012 | Televison & Video
Mar 12, 2007 | Hitachi 61UWX10B 61" Rear Projection...
2,151 people viewed this question
Usually answered in minutes!