Maxtor 52049U4 jumper - Maxtor DiamondMax Plus D740X (6L020J1) 20 GB Hard Drive

This WEB site shows the jumper settings for your hard drive.
http://users.tkk.fi/vlehtola/maxtor.txt

1. Jumper settings for model 7245At refer to LINK

2. jumper settings for model 52049h3 refer to LINK

Hope it helps.

MAXTOR: no jumpers --> Master
one jumper --> Slave
two jumpers --> Cable Select

hello

go to this link.. it will illustrate jumper setting

http://sysdoc.doors.ch/MAXTOR/diamondmax_30_vl_ultra_ata_66_quick_specs.pdf

No jumper is used on the J50 pins, when using the Maxtor 5T020H2 IDE harddrive, as a Slave harddrive.

In otherwords do not use a jumper on any of the jumper pins.

This is a PDF file of the Harddrive Specifications of the 5T020H2, 5T010H1, 5T030H3, 5T040H4, and 5T060H6 Maxtor IDE harddrives,
from Seagate. (Seagate bought out Maxtor)

http://www.seagate.com/staticfiles/maxtor/en_us/documentation/manuals/dm_plus_60_ultra_ata_manual.pdf



The Jumper Settings are in Chapter 2, Page 5 (2-5)
Looking at the page number for the PDF file it's on Page 15.

For use as slave there is no jumper connected. (Master on/slave off0

Select the maxtor HDD as master by setting the Jumper to the extreme left of the hdd; i.e. next to the data cable.
Remove all jumpers from the other HDD which you want to put as slave.

Look on the label on the drive itself

no jumpers = slave
FAQ here
http://seagate.custhelp.com/cgi-bin/seagate.cfg/php/enduser/std_adp.php?p_faqid=341&p_created=985649154

There should be a diagram showing how you should set the jumper. Set it according to what you want it to be and it should begin to should up. You can set it as Master, Slave, or Cable Select.