I need the operating instructions for a candy aquaviva cd623 dishwasher. Can anyone help with a pdf version I can download?

Actually every dishwasher I've worked on had one water inlet and it was always for hot water. Approximately 3 gallons per cycle.

Try this link & check that model number. They had a 252 but no 242: http://service.candy-domestic.co.uk/manuals/Manuals.aspx?Section=3

First check and see if there is plenty of water coming into the machine by examining the fill hose inself.
You likely will have to disconnect that hose, not at the machine end, the sink end.
Then, find a way to test the wires to the fill valve, should likely be 110 volts when the machine starts, allowing the fill valve to open.
A volt-ohm meter will tell you, set it to over 110 volts on the A.C. setting.
If no power to the fill valve, you may be facing a new timer.
Be blessed.

search the internet for
NTC 49009410
Look for PDF and you may find something that helps

Hi,

Here is a tip that I wrote about dishwashers and them leaking.

Leaking Dishwasher

heatman101

v

The water hasn't drained away after the cycle

Their is not condensor on a dish-washer?

Do you hear a humming noise? Do you mean your motor? Have your tried rotating the motor fan blades to unjam the motor?

Chances are its the wash pump, when you tip it back are you able to see the workings underneath the Dishwasher, if so you will see a largest looking Motor (wash pump) look to see if there is any water marks or rust on it, if there is then this is probably your problem, if thats the case a new wash pump would cost around 100 pound.

Chances are its the wash pump, when you tip it back are you able to see the workings underneath the Dishwasher, if so you will see a largest looking Motor (wash pump) look to see if there is any water marks or rust on it, if there is then this is probably your problem, if thats the case a new wash pump would cost around 100 pound.

not familiar with model. element can be inside cabinet in which case it will be obvious or may be in a cylinder heater mounted in the base. suspect stats as well or possibly the module