Question about Projection Televisions

1 Answer

The sound of my tv is in background, I can't hear ear it correctly even if the volume is high. I went in the options to put the speakers on, it's on. The cyclone is on aswell. Except the audio menu, I don't see anywhere I could go to make it work. Thank you

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 44 Answers

Turn off all automatic settings in the audio menu as well as any surround settings. Surround settings and auto level settings often cause this.

Posted on Nov 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My volume is very low and I can only hear from one speaker


If your TV has a headphone jack, plug some headphones into it and see if the volume works there. If so, make sure the speakers are correctly connected to the TV and that both the wires and speakers are good. (Try other speakers).

Sep 10, 2013 | Mitsubishi WD-52528 52" Television

1 Answer

I have a volume problem. When I adjust the volume at a listening level, a high pitch sound can be heard then the volume turns low and goes back to the set level. It happens in every channel (Direct TV)....


No ,replacing speakers will not fix the problem these sets are very well know for Poor Solder and connection ,resolder signal,Audio,& power supply boards this should correct the problem and alot of future ones too.

Sep 16, 2009 | Mitsubishi WS-65711 65" Rear Projection...

1 Answer

Was watching TV and the sound stopped working.


problem with your tv amplifier. place your ears near the speakers, adjust the volume up and down several times, you should hear a soft whistling sound going up and down. if not the problem is before the amplifier stage. visit your service center.

Jul 08, 2009 | Toshiba 51H84 51" Rear Projection...

1 Answer

No Sound on Toshiba 57H81 projection TV. Picture is fine.


The sound amplifier IC has went bad and needs replaced. Call a good TV Tech.
Check with the BBB 1st before you decide on one.

Jun 19, 2009 | Toshiba 57H81 57" Rear Projection...

1 Answer

We were watching a tv program and the tv went black. we cannot get it back on


As a basic troubleshooting technique, technicians first determine if there is high voltage or not upon power up and if there is, if it is sustained high voltage. This basic test can be performed by putting your ear to the back cover of the unit and then turnng on the unit. If you hear a sweeping noise such as that of an air compressor shooting air through a nozzle, it means there is high voltage.

If there is high voltage it it important to determine if the high voltage collapses or not after power up.

If you will et me know results of this test, I can assist you futher.

Apr 29, 2009 | Projection Televisions

1 Answer

Sharp 19" LCD TV Volume is low on many channels even when turned all the way up as high as possible. I've checked sound settings, balance, etc. Don't know what else to do - can I add external...


The sound is just a bonus on big tv's anyways. If something went wrong, it not going to be an ez fix. Just use external audio. Better the audio burns out then the video.

Nov 14, 2008 | Sharp Projection Televisions

1 Answer

I've just purchased a Sanyo 19" LCD High Definition Televison for my aunt. She is hard of hearing and I've used ear phones on her last two Tv's. Is there a way to attach ear phones to this TV? Thank...


Most TV manufacturers no longer put headphone jacks on the TV's. None of the audio outputs will have the correct impedance for a set of headphones. The most reasonable option I think would be to see if your local electronics or audio store has a small headphone amplifier that can be plugged into the audio line out RCA jacks.

Sep 06, 2008 | Projection Televisions

1 Answer

Volumn Control on my 36


I have to turn my volumn to 100 to hear it and the tv is 1 month old.

Mar 14, 2008 | Mitsubishi VS-60603 60" Rear Projection...

1 Answer

No Audio Out to Stereo Reciever


First have you went in menu and check audio to see if you are on the variable audio or external output? Check to see if this makes a different with audio jack hookedup correctly of course!

Sep 11, 2007 | Hitachi 51F510 51" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...