The electric control panel

Do you have digital reading on your stove panel?Is it giving you a code reading.

Well, your temp sensors can still be bad. If not, there's always a new control board you buy!

However, I wouldn't drink water from that oasis without making ABSOLUTELY sure I'm not seeing a mirage.

The only common denominators between your upper and lower oven temp readings is the firmware and the oven thermometer you are using to visually check the temps.
What type of thermometer are you using to check your oven temperatures with?
If it's not a digital thermometer used specifically for testing ovens, you might just be leading leading yourself astray.
You need a calibrated thermometer. If I don't have a calibrated digital thermometer on me, I use two or three oven thermometers (the dial type) and average the readings.
It's the only way to be as close as possible with a digital probe.

If you have thoroughly verified that your oven is in fact not reading the correct temperature, then you can adjust it +/- 35 degrees F via your oven's control panel.
To adjust the oven temperature:
1 - Press Setup pad.
2 - Select the down arrow to scroll to the next screen.
3 - Select Temp Adjust using the Quickset pads.
4 - Select upper or lower oven (select models).
-"Set temperature offset using the Upper Set Knob" is displayed.
5 - Enter the desired temperature change using the Set knob.
The temperature can be increased or decreased up to 35 degrees.
The temp. change is displayed at the top of the window.
6 - Press the Set knob to accept the change.

Now, if you are still worried about the temp. reading being off, replace both the upper and lower temp sensors. That's all you can do besides replace the main board.

Hi

This means a loose/broken wire on the oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that and the door appears to be closing fine then it is the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.
Daniel

Hi

This means a loose/broken wire on the oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that and the door appears to be closing fine then it is the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.
Daniel

Sorry to read about your problem, I hope this helps you out.

Bad gas control valve or oven temp control

I tried to help you. Please help me and Rate/Vote on my response, thanks and good luck

sounds like it is the wrong one pretty common problem with those control panels

Hi,
Before you go working too hard to get you oven to go into the self clean mode....check out this tip...


http://www.fixya.com/support/r3969401-self_cleaning_oven_problem http://www.fixya.com/support/r4511800-oven_problems_electric_oven_heating



heatman101

" Wish I had read this first. I never would have used the self cleaning option. Thanks for the info!! "

Digital control responds by setting temperarature but nothing happens. Check temperature probe with ohm meter. Small pencil diameter metal tube. Shoulr read something near 1089 ohms depending on the ambient temp of your home. If that checks okay replace the control board.

Hi!! you seem to have a bad control board its on the back top panel its shorting out.replace ut and you should be fine..Good luck..

The electronic control board will have to be replaced