Question about Zanussi 24 in. DA6153 Free-standing Dishwasher

1 Answer

Frigidaire D/W. Model fd8750rcc0

The dishwasher is not draining. The pump runs as water sprays during the wash cycle. total silence when I think it should drain. hose is not clogged. Do you think it might be related to the timer or to the drain pump assy? could it be many other things?

Posted by on

  • Anonymous Dec 10, 2008

    I have the same problem with my Zanussi DW 917. It washes OK but doesn't drain the dirty water away at the end of the cycle.

    Any advice appreciated.

    Cheers

    Julie


×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,239 Answers

Hi Dishwashers usually run on 115-volt or 120-volt power. The water they use comes directly from the water heater, and wastewater is drained into the sink's drainpipe. The dishwasher is not connected to the cold-water supply. For best dishwashing results, set the temperature control of the water heater to no less than 140 degrees Farenheit. Water cooler than this usually doesn't get the dishes clean, unless your dishwasher is a newer model that preheats incoming water. The water shutoff for the dishwasher is typically located below the adjoining sink.

Posted on Nov 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whirlpool integrated dishwasher model ADG 7460 Have run the engineer test cycle and it stops and drains water after 2 mins; start light blinks 5 times.


F5 or 5 times flashing.
Variable speed motor failure.

Reason:
- Connection between Spray pump (Variable speed motor) and control board interrupted.
- Frequency converteron Spray pump broken or control board defective.

= Check the power voltage on the motor. BUS: 5V DC, Motor: 230V AC

Reaction: Cycle stops, drain pump drains out,failure indication.

OR

F5 or 5 times flashing.
SPM blocked (MPH motor unit)

Failure condition:
- This failure is only indicated during the active test program
- The electronic detects an irregular deviation of the motor current consumption.

Reason:
Spray pump blocked = check pump housing
Short circuit in motor or wiring = check motor values

Reaction: After 5 attempts to reactivate the spray pump motor the cycle stops, drain pump drains out, failure indication.

Dado

Sep 03, 2015 | Whirlpool Dishwashers

1 Answer

Frigidaire FFBD2403LW normal cycle hum


Hello ddux97 - Often this occurs because either not enough water is being pumped to the spray arm or in other words the full flow of water is not making it to the upper spray arm. Will the spray arm rotate freely? If it does not, then you might have to remove or replace the spray arm assemblies since it is possibly damaged. Confirm that the drain hose is strapped up properly under the sink to prevent the water from siphoning out during the cycle. If issue persists, I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if the unit's status has changed successfully.

Jun 20, 2013 | Frigidaire Dishwashers

1 Answer

I have a year old kitchen aid dishwasher and during fill cycle it makes a thumping noise. The dishwasher every 5 or 10 seconds shuts off fill cycle then turns back on which I think is what's causing...


Drain Pump

If the dishwasher is loud during operation, the drain pump might be defective or might have some debris in it. This is a common problem.


Enter your model number to see parts for your dishwasher.
Help me find my model number


Circulation Pump

If the dishwasher is loud during operation, and the noise is a continuous drone similar in speed to the circulation pump sound, it's likely that the circulation pump motor bearings have failed. Once this happens the circulation pump will have to be replaced, the bearings are not repairable.


Enter your model number to see parts for your dishwasher.
Help me find my model number


Drain Impeller

If the dishwasher is loud during operation, the drain impeller might be broken, or there might be debris in the pump. Generally, to gain access to the pump the top of the pump housing will have to be removed.


Enter your model number to see parts for your dishwasher.
Help me find my model number


Pump and Motor Assembly

If the dishwasher is loud the motor bearings, drain impeller or wash impeller might have worn out. All three of these components are part of the pump and motor assembly. It may be possible to replace one of the impellers, but the motor bearings cannot be repaired. In that case the pump and motor assembly will need to be replaced.


Enter your model number to see parts for your dishwasher.
Help me find my model number


Wash Impeller

The wash impeller is a small, plastic blade. The motor spins the impeller forcing water through the spray arms to clean the dishes. If one or more blades has broken off of the impeller the dishwasher is loud. The impeller can also scrape against the pump housing if it is damaged, warped or bent.


Enter your model number to see parts for your dishwasher.
Help me find my model number


Circulation and Drain Pump Motor

If the dishwasher is loud during operation, and the noise is a continuous drone similar in speed to the motor sound, it's likely that the circulation and drain pump motor bearings have failed. Once this happens the motor will have to be replaced, the bearings are not repairable.


Enter your model number to see parts for your dishwasher.
Help me find my model number


Water Inlet Valve

The water inlet valve is an electrically controlled water valve. When it is new, the water inlet valve is very quiet. Over time, the diaphragm inside the valve deteriorates and deforms. This deformation interacts with the water rushing in and can cause a loud vibration, buzzing, squealing or other noises. If the dishwasher is loud during the filling cycle, replacing the water inlet valve may solve the problem.

God bless you255fe28d-9cc9-4874-b381-9c9de59f3f75.jpgc98d91d6-ba21-42ff-b684-98f0b3e856c0.gif

May 24, 2013 | Dishwashers

1 Answer

I have a whirlpool Adp8540 that seems to go through the wash cycle completely but when we open it up the water has not gone through the spraying arms and the soap is a solid mass at the bottom of the...


It is likely the water circulation system is faulty. This dishwasher uses a single motor to run the water pump and the drain pump. If you hear the wash pump operate during wash cycle then it is likely there is a blockage in the water circulation manifold which distributes the water through the arms.

If you do not hear the pump operate during wash cycle then the sensor is faulty. The sensor tells dishwasher to switch to drain cycle from wash cycle.

Try following the diagrams at top of this website to get idea of parts.

Oct 13, 2011 | Dishwashers

1 Answer

Fdb126rbs2 fills and drains fine but does not


DO YOU HEAR THE MOTOR START OR HUM AFTER THE WATER FILLS? IF IT RUNS CLEAN YOUR FILTER AROUND THE BOTTOM OF THE LOWER SPRAY ARM INSIDE. LET ME KNOW IF YOU HAVE MORE INFO.

Apr 25, 2010 | Frigidaire 24 in. FDB126RB Built-in...

1 Answer

Dishwasher motor sounds like its struggeling to run. oR LIKE it's bogging down during washing cycles any and all cycles. there is water going into the washer but when washing it sounds like there is no...


Try pouring water from the front. The pump has got air traps inside. This will ease your problem.

Also check whether the spray arm turns freely without any obstacles.

Mar 30, 2010 | Frigidaire 24 in. FDB510LC Free-standing...

1 Answer

GE Triton Dishwasher fills with water but no spraying occurs.


Trouble shooting GE dishwasher
Model GSD6600G00WW

Air gap is clean
Garbage disposal is clean
Dishwasher fills with water OK
Drain pump runs after a wait of several minutes and seems to run slow but drains most of the water out of the reservoir.
Dishwasher is not running the wash cycle (spraying water on dishes)

Jan 27, 2009 | GE 24 in. GSD6660GSS Built-in Dishwasher

1 Answer

DISHWASHER


faults not related i would think is there a low humming noise when supposed to be wsahing? if so this is the motor capacitor faulty in all probability. this is a cheap part and easy to replace. otherwise, check if power to pump. if no power then points to a module fault. if there is power, points to a motor fault

Jun 22, 2007 | Frigidaire 24 in. FDB421RF Built-in...

1 Answer

Dishwasher Repair


Ebers, you have a seperate wash and drain motor on this model. When you remove the bottom panel the drain pump will be on the right and the circulation (wash) pump will be in the rear. You are going to have to verify that you have power getting to the wash motor. Sometimes this is difficult without removing the dishwasher. The motor may have a quick connect harness going to it that you can check voltage there. If you have voltage to the motor during the wash cycle and it's not running, well, there's the problem. If no voltage, then it's probably a timer issue. Catriver..post back

Feb 05, 2007 | Frigidaire 24 in. FDB421RF Built-in...

3 Answers

The dishwasher in my kitchen doesn't seem to drain and it seems pump is not working


I INSTALLED A NEW GARBAGE DISPOSER AND THEN FOUND THAT THE DISHWASHER WOULD NOT DRAIN. READ THAT THERE WAS A SEAL IN THE NOZZLE OF THE GARBAGE DISPOSER THAT HAS TO BE REMOVED IF IT IS ATTACHED TO A DISHWASHER. I DISCONNECTED THE HOSE,WITHOUT REMOVING THE GARBAGE DISPOSER, PLACED A SCREWDRIVER IN THE HOLE AND HIT IT WITH A HAMMER AND KNOCKED IT OUT. REPLACED THE HOSE AND TIGHTENED THE RING AROUND THE HOSE. TURNED THE DISWASHER TO DRAIN AND IT WORKED PERFECTLY. MY MISTAKE FOR NOT READING THE DIRECTIONS THOROUGHLY. ALL IS WORKING WELL; HOPE THE SAME FOR YOU.

Sep 26, 2006 | Frigidaire 24 in. FDB510LC Free-standing...

Not finding what you are looking for?
Zanussi 24 in. DA6153 Free-standing Dishwasher Logo

191 people viewed this question

Ask a Question

Usually answered in minutes!

Top Zanussi Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

paulcarew

Level 3 Expert

1862 Answers

Are you a Zanussi Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...