Question about Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Whirlpool duet washing machine

Control locked. How do I unlock it.

Posted by on

  • acj_44 Nov 06, 2008

    My whirlpool duet is a piece of junk-Everytime I use it it starts beeping and flashed either dl, F11, F14-and then stays locked-I cannot open the door to get the clothes out. It takes a full day to get clothes washed-one load I mean-any ideas?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

The Duet washer is a good machine, just unfortunate Whirlpool engineers used oxidative circuit board coatings. All the circuit board connections are oxidizing causing the machines to have faulty connections. We have fixed the problem using this information.
UNPLUG the machine first . Take the top off (3 screws in the back) , remove the mother board box from the frame housing and remove the lid. Now you can see the circuit board.
Carefully remove ONLY one (clip plug-in) at a time. Scrap with a (knife or sandpaper or steel wool ) the edge connector where that plug was, on the circuit board removing the oxidated metal (it may not look oxidated but must be cleaned), Next put ( vaseline or mineral oil) on the edge connector where that plug was, NOTE: Vaseline or mineral oil is a non-conductive oil and will not effect electronic operation but will prevent further oxidation and the erratic operation of the mother board will cease.
Now do the next plug and repeat until completed.
NOTE: We recommend only one plug at a time so you do not get confused where each plug belongs.
Put the cover back on the mother board box and reattach to the frame, then put the lid back on and screw it down. End of any problems.

Posted on Nov 11, 2008

5 Suggested Answers

  • 1 Answer

SOURCE: whirlpool duet washing machine ghw9100lw1

To turn off "Control lock" : press and hold the "End of cycle signal" button for three seconds.

Posted on Feb 23, 2008

  • 1294 Answers

SOURCE: control lock is on

Right of control panel "end of cycle", keep pressed for 3 seconds.

Posted on Apr 11, 2009

  • 54 Answers

SOURCE: Control Locked light is on. How do you clear the problem?

if it is stuck on, like the power went out and when it was restored mine did this once, pull the power cord from the wall and count to 10 then plug it back in and see if that works.

Posted on Jun 04, 2009

57 varieties
  • 1653 Answers

SOURCE: how do you get control lock off whirlpool duet

To unlock the Control Locked feature:

Press and hold the End Of Cycle Signal button for 3 seconds to turn this feature off.

NOTE: When the machine is running and Control Locked light is on, the machine can be stopped by pressing the Pause/Cancel button, but cannot be restarted until the control is unlocked.

Posted on Oct 02, 2009

  • 1 Answer

SOURCE: unlock control lock in washing machine, whirlpool, duet

my whirlpool heaavy duty 9Kg is locked so I can't unlock it, I need help please

Posted on Aug 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you unlock a whirpool duet control panel?


Press and hold the "End of Cycle Signal" button for approximately three seconds until the "Control Locked" indicator light shuts off. This unlocks the control panel so that the washer is ready for use.

Read more : http://www.ehow.com/how_5701217_unlock-control-whirlpool-duet.html How to Unlock the Control on Whirlpool Duet eHow

Sep 29, 2015 | Washing Machines

Tip

Hoe to unlock the controls of whirlpool washing machine


  1. To unlock the controls: Press and hold the End Of Cycle Signal button until the Control Lock light goes Off. To lock the controls: Press and hold the End Of Cycle Signal button until the Control Lock light comes On.

write_tip-sap4owyfpomquw3pehjkxnse-3-0.jpg


write_tip-sap4owyfpomquw3pehjkxnse-3-2.jpg

on Aug 24, 2015 | Whirlpool Duet GHW9150P Front Load Washer

3 Answers

Control is locked


To unlock the controls
Select and hold END OF CYCLE SIGNAL for 3 seconds until the
CONTROL LOCKED Status light turns off.

Feb 12, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

How do you get control lock off whirlpool duet washing machine


To unlock the Control Locked feature:

Press and hold the End Of Cycle Signal button for 3 seconds to turn this feature off.

NOTE: When the machine is running and Control Locked light is on, the machine can be stopped by pressing the Pause/Cancel button, but cannot be restarted until the control is unlocked.

Oct 02, 2009 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

WHAT IS 'CONTROL LOCK' ON THE WHIRLPOOL DUET


Control Lock is a designed safety feature that allows you to lock/unlock the control panel to prevent small children from manipulating the controls. To lock or unlock the control panel, click on the following link:

http://www.fixya.com/support/r2469429-kenmore_elite_amp_whirlpool_duet

If this does not fix your problem, please let me know. I hope this helps you.

Jul 11, 2009 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Control lock is on


Right of control panel "end of cycle", keep pressed for 3 seconds.

Apr 11, 2009 | Whirlpool Duet GHW9150P Front Load Washer

2 Answers

Unlock control lock in washing machine, whirlpool, duet


Hold control lock for 3 sec. It will make a sound and the door will unlock.

Mar 21, 2009 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

CONTROL LOCKED


I you push and hold the END OF CYCLE SIGNAL button on the left of the control panel for three seconds, it should unlock the control panel.

Apr 11, 2008 | Whirlpool Duet GHW9150P Front Load Washer

Not finding what you are looking for?
Whirlpool Duet GHW9150P Front Load Washer Logo

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...