Question about Samsung TXE2746 27" TV

2 Answers

Have to turn tv on and off to get picture

I have an old Samsung TXE 2746 and this week, when I turn the tv on, the picture is fuzzy and it seems like it's not connecting to the cable. I have to turn the tv on and off repeatedly before the station comes in.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 981 Answers

Timing crystals can turn to trash on you, if not their tuning circuits. Try subbing in a new crystal or resettable oscillator to see if it perks right up as far as tuning. There's usually a few electrolytes (.5 uf timing drift capacitors) around there to test at frequency or swap out at little cost if that fails.

Posted on Jan 27, 2011

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

You seem to have tuner problem. has been a problem with the older model Samsung.

Posted on Nov 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diagram TV Samsung TXE 1970 I have this TV Model and I have problems with the volume bar, it remains stuck on the max level on the screen. I can't get the volume up. But when I get the volume down (on the...


have you tried physically unplugging the unit from the wall. wait 2 minutes. this resets the microprocessor computer part of the tv. then plug it back in. fixed. the computer is confused. unplug. plug back in

Nov 14, 2009 | Samsung TXE1970 TV

1 Answer

Samsung HLM507 FLICKERING PROBLEM


how extended is that warranty, and what does it cover? Sounds to me like a classic video controller board about to fail.

Mar 24, 2008 | Samsung DLP HL-P5663W 56" TV

1 Answer

I have a Sharp 32" Standard TV ... picture will get fuzzy either due to someone walking by or sometimes if sound coming from tv is vibrating. If we shut tv off and turn it back on it is clear again. The...


Hello: Your problem seems to be in or around the tuner of the television, More then likely you have cold solder joints on the turner that needs to be resoldered. Also check the coax end protruding from the back of the set where u connect the cable and make sure it is not loose, a bad ground on this connector to the turner shield will cause this symptom. My professional diagnostic is that when the television is cold the solder connections are making contact with the board, and as heat builds up in the television while watching these connections tend to seperate and make limited contact, causing fuzzy picture and in most cases no picture just snow...

Sep 06, 2009 | Sharp 32C-240 32" TV

1 Answer

Dropped my tv and the screen is fuzzy


the picture tube of your tv is damage /broken. You can replace the tube on the other brand as long as it is thessame size.

Jul 29, 2009 | Standard (CRT) Televisions

1 Answer

Toshiba 32" tv wont give sharp picture (other tv does)


try to replace filter capacitor from power supply and in horizontal section.

Jan 26, 2009 | Toshiba 36A50 36" TV

1 Answer

TXJ2066 Samsung


  • your problem is due to crt getting weak
  • because of that you are getting fuzzy picture.
  • good luck.

Oct 23, 2007 | LG 30FS1D TV

1 Answer

SAMSUNG TXE-1986W TELEVISION


The front inputs aren't viewed on a "channel". You would have to press the "Source", "input", or "TV/Video" button to access the front input. On rare occasion you can press 00 on the remote to get there or go to channel 1 and press "channel down" but not always.

Sep 08, 2007 | Samsung TXE1986 TV

1 Answer

The picture on my tv is fuzzy


Check your connections Inm the Back of your Tv and Also see If your VCR got turned on By Mistake....

Jul 18, 2007 | Insignia IS 20" TV040919 TV

1 Answer

Picture fuzzy


I would suggest to unplug the tv from the wall for about 15 minutes and then plug it back in,and turn it on,this should reset the microprocessor and realign the colors back to normal.let Us know how it goes and if you need more help.

Oct 12, 2006 | Sony FD Trinitron WEGA KV-24FS120 24" TV

2 Answers

Fuzzy signal


Right, but the problem is more likely the tuner unit-which the coaxial is hooked up to. If it was strictly the coax, when you wiggled the cable around, the image would probably come back fine. Youll have to get a tuner and solder out the old one, the solder in the new one. The tuner for your model is part QAU0305-001 found here: http://www.jvcservice.com/service/JMdlPrtXrf.asp?PgReq=DspDta&MdlNbr=AV-32432 Be aware that the problem could be as simple as a diode or cap...until it can be tested we don't know for sure. techman would probably know more about this model than I would.

Apr 21, 2006 | JVC AV-32432 32" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68352 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Samsung Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...