Question about Canon PowerShot SD550 / IXUS 750 Digital Camera

1 Answer

How can I fix this issue with the camera, on the canon powershot sd750 digital elph 7.1..lcd reads lens error restart camera

How can I fix this issue with the camera, on the canon powershot sd750 digital elph 7.1.....lcd reads lens error restart camerA

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Canon Master
  • 96,467 Answers

×

6 Suggested Answers

t00nz
  • 4738 Answers

SOURCE: Digital Camera

The following blog outlines some repair options for a lens error:
http://camerarepair.blogspot.com/2007/12/fixing-lens-error-on-digital-camera.html

Posted on Dec 26, 2007

informatica
  • 1113 Answers

SOURCE: HOW DO I CHANGE FROM

Hi - You can download the manual by clicking the link underlined in blue below:

POWERSHOT SD750

See page 58:

65813b2.jpg

1fa89b1.jpg

Please take a moment to rate this solution & let us know if the information given was useful to you - Good Luck!

Informatica

Posted on Sep 26, 2008

  • 489 Answers

SOURCE: lens error restart camera SD750

somebody saying under warranty

http://www.digitalcamera-hq.com/digital-cameras/canon-powershot-a570is_question.html?qid=12688

Posted on May 30, 2009

SOURCE: lens error

yes, this happened to me, what you have to do is "snap" the lens back in place, if it is bent anyway. if it is not bent and it says lens error, does it the lens come in and out? if not then it is bent if so then there is a hardware error in the switch and you will have to send it to a profesionall. :) hope i could be some help :)

Posted on Jun 17, 2009

  • 11967 Answers

SOURCE: canon sd750 powershot lens error

Fixing a Lens Error on a Digital Camera

This has to be THE most common failure mode for a digital camera. Some common error messages that might show up on the LCD's of cameras with this problem include “E18 lens error”, or “lens error, restart camera”. Some cameras might show nothing at all, but merely make a beeping noise as the lens goes out, then in, then the camera shuts off. Sometimes the lens won't even move.
The problem is actually quite common throughout all camera brands. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or the battery ran down with the lens extended. Believe it or not, one BIG contributor to lens errors is using a camera case. Sand, gunk, case fibers, etc... accumulate at the bottom of the case. These materials love to cling to the camera by electrostatic build-up from the camera rubbing against the side of the case (especially those cases with soft fibrous intreriors). Once these materials work their way into the lens mechanism, that's all she wrote. I have many Canon's, and NEVER use a case for this very reason.
A camera owner that suffers this problem may have no recourse for having the camera repaired. Many camera makers will not honor repairing this problem under warranty as they claim it is due to impact damage to the camera, or sand or debris getting into the lens gearing mechanism (neither of which is covered under warranty). The quoted repair cost is usually close to or more than what the camera is actually worth.
Fortunately, about half the cameras that suffer this failure can easily be fixed by one of the following methods. None of these methods involve opening the camera, although some have potential to cause other damage to the camera if excessively done. If the camera is still under warranty, before trying any of these, please please first contact your camera's maker to see if they'll cover the repair, or to determine how much they'll charge for the repair. Who knows, you might get lucky. But if they quote you a number that's higher than the value of your camera, you may want to consider the following methods.
The methods are listed in the order of risk of damaging your camera. Thus make sure you try them in the listed order. And remember, these fixes (especially #6 and 7) should only be considered for a camera that's out of warranty, who's cost of repair would be excessive, and would otherwise be considered for disposal if unrepaired:
Fix #1: Remove the batteries from the camera, wait a few minutes. Put a fresh set of batteries back in (preferably rechargeable NiMH 2500mah or better) and turn the camera on. If that didn't work, try pressing and holding the Function or OK button while turning the camera on.
Fix #2: Remove the batteries, then remove the memory card. Then install new batteries, and turn on the camera. If you get an Error E30, it means you don't have a memory card installed, so turn it off, slip in the memory card and turn it on one last time.
Fix #3: Insert the cameras Audio/Video (AV) cable, and turn the camera on. Inserting this cable ensures that the camera's LCD screen remains off during the start process. Thus extra battery power is available to the camera's lens motor during startup. This extra power can be useful in overcoming grit or sand particals that may be jamming the lens. If the AV cable doesn't fix the lens error by itself, consider keeping this cable installed while trying fixes 4, 5, and 7 as a means to provide extra help to these fixes. But note that I DON'T recommend keeping the cable installed during Fix 6 as you may damage the AV port while tapping the camera. Reinsert the cable only AFTER tapping the camera.
Fix #4: Place the camera flat on its back on a table, pointed at the ceiling. Press and hold the shutter button down, and at the same time press the power-on button. The idea is that the camera will try to autofocus while the lens is extending, hopefully seating the lens barrel guide pins in their slots.
Fix #5: Blow compressed air in the gaps around the lens barrels with the idea of blowing out any sand or grit that may be in there jamming the lens. Other variations include blowing with a hair dryer in “no heat” setting, or sucking the gaps with a vacuum (careful with this one).
Now we're entering into the realm of potentially damaging your camera in conducting the fix. There is definitely some risk here, so take care when conducting the following two fixes.
Fix #6: Repeatedly tap the padded/rubber usb cover on a hard surface with the intent of dislodging any particles that may be jamming the lens. Other variations include hitting a side of the camera against the palm of your hand. A lot of people have reported success with this method. HOWEVER, there is also some potential for damaging or dislodging internal components with this method, such as unseating ribbon cables, or cracking LCD screens.
Fix #7: Try forcing the lens. More people have reported success with this method than with any of the other methods. HOWEVER, there's obviously some potential for damaging your camera by using this method. Variations include gently pulling, rotating, and/or twisting the lens barrel while hitting the power button. Attempt to gently straighten or align the barrel if it's crooked or twisted. Another variation includes looking for uneven gaps around the lens barrel, and then pushing on the side of the lens barrel that has the largest gap (note pushing the lens barrel all the way in is NOT recommended as it may become stuck there). While doing any of the above, listen for a click that indicates that the lens barrel guide pins may have reseated in their guide slots. If you hear this click, immediately stop and try the camera.

Posted on Jan 26, 2010

  • 1 Answer

SOURCE: "lens error, restart camera" for canon powershot SD1200IS

problem in canon digital camera ixus 95 is
Do not open Power has never changed the battery and another also does not start

Posted on Feb 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a canon powershot sd750 and when i turn my camera on it says lens error, restart camera


Hi Shawn,

Check the link below and you will be able to fix the issue by doing the troubleshooting.

Click here - > Camera Troubleshooting

Regards,
Suhail

May 17, 2012 | Canon PowerShot SD700 IS Digital ELPH /...

1 Answer

Have a canon digital elph sd750. Pictures are now blurry.


You could have cracked the lens, damage the focus or a number of other things but the lens and focus are most likely. check your lens for scratches if there is none and no cracks take it to your nearest camera store or buy new good luck!

Aug 08, 2009 | Canon PowerShot A75 Digital Camera

1 Answer

Lens error restart camera SD750


somebody saying under warranty

http://www.digitalcamera-hq.com/digital-cameras/canon-powershot-a570is_question.html?qid=12688

May 30, 2009 | Canon PowerShot SD750 / IXUS 75 Digital...

1 Answer

PowerShot SD630 lens stuck out, says lens error, restart camera


This is probably THE single most common failure among digital cameras. There's a halfway chance of fixing it yourself, described here: http://camerarepair.blogspot.com/2007/12/fixing-lens-error-on-digital-camera.html

Apr 20, 2009 | Canon PowerShot SD630 Digital ELPH / IXUS...

1 Answer

Canon camera when turned on, lens will not


Hi

What you are seeing is a generic error message, starting your camera again won't do anything unfortunately.

You need to replace the lens, we have your lens repair available on our site for about $75! If we can help please let us know.

Thomas
Owner- Darntoothysam com

Apr 04, 2009 | Canon PowerShot SD750 / IXUS 75 Digital...

2 Answers

PowerShot SD630 lens stuck out, says lens error, restart camera


I've had similar problems with various versions of this camera. Here's the fix, if all else fails. These are step-by-step instructions to take apart and fix the camera's lens error. http://johnsmouth.wordpress.com/2010/12/01/lens-error/

Mar 24, 2009 | Canon PowerShot SD630 Digital ELPH / IXUS...

1 Answer

Lens error, restart camera


the beeping sounds means that your camera lens is stuck. contact the manufacturer (canon), for a possible solution...or they can even send u a new one. My friend dropped her SD630 and had the same problem...she contacted canon, and sent in her camera to be fixed, but it wasn't fixable, so canon sent her a brand new camera. hope this helps.

Jun 14, 2008 | Canon PowerShot SD630 Digital ELPH / IXUS...

1 Answer

Canon PowerShot SD630 LENS WONT CLOSE,LENS ERROR RESTART CAMERA


I have the same problem. How do you restart the camera. I have pulled the battery and SD card, but can't get to a menu screen to restart to camera.

Apr 16, 2008 | Canon PowerShot SD630 Digital ELPH / IXUS...

Not finding what you are looking for?
Canon PowerShot SD550 / IXUS 750 Digital Camera Logo

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top Canon Digital Cameras Experts

Doberman

Level 2 Expert

246 Answers

Tony

Level 3 Expert

2598 Answers

halotheracer
halotheracer

Level 2 Expert

68 Answers

Are you a Canon Digital Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...