Cdx65 xchanger says reset and i do and it does nothing

Press and hold the start button for a few seconds. The dishwasher will drain and reset

Need a new thermostat to keep the unit from tripping

Should be printed on the CD case, or inside the instructions in the box. If you have lost these you can contact the manufacturer and see if they can pull it up by your name based on the orginal registration when you bought the software.

FIXYA POSTED SOLUTION http://www.fixya.com/support/t99401-hotsync_requires_reset
HotSync menu select Custom, change System to HandHeld overwrites Desktop, set as default. It is probably set to Desktop overwrites Handheld

I would only assume that now you have taken out an over heating sensor. When a heat exchanger goes bad it is a very dangerous situation because now you are pumping carbon monoxide in your house along with your heat. A heat exchanger is a baffle that hot gases pass thru, heating up the exchanger along the way and expelling carbon monoxide out the exhaust/chimney. Bad exchangers crack along seams or burn holes thru allowing the exhaust to mix with the blower air and in time this could cause carbon monoxide build up in your house. This cracking also lets hot exhaust in to the furnace and can burn up over heat protection, wiring and possibly cause a house fire. Please change out the heat exchanger or entire furnace, there is no price to replace a human life.

DOWNLOAD THEMES FROM WAPKING.MOBI OR XCHANGER.COM

The manifold pressures must be 11.5 in or mor up to 13 some places, see that its not beeran with nat gas orifices, if it has it must be pulled and clen heat exchangers

i turn on my gps on itz froze aint nothing comming up after

HOLD THE ON OFF SWITCH DOWN AND youPRESS RESET This should reset it back for t

Do a reset. Check TomTom website to find where your reset hole is. Use a paperclip to do the reset.