Question about Mobility Scooters

Open Question

I need a wiring scomatic for a zongq motor 48cc

I have a scooter with a 48cc engine and the company that made the scooter is zongq. i need a copy of the wiring scomatic. so i can wire up the scooter. email me at cheshire.jonathan@yahoo.com

Posted by on

2 Suggested Answers

  • 1 Answer

SOURCE: mobilty scooter fault

i have a shoprider mobility scooter has soon has i turn on it goes about 5 yards and stops and the alarm comes on i think it has something to do with the brake system could anyone advise me on what it could be thanks

Posted on Sep 21, 2009

  • 692 Answers

SOURCE: need schemitic for wiring on

I have the schematics on my computer in PDF format. If you send me your e-mail I'll send you the printouts that I hope will help E-mail me at lennieg2000@yahoo.com

Posted on Aug 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Got a new motor for pride victory 9 3 wheel scooter, new wires on new motor with plugins on end of wire. How does old wires come out of junction box on back of scooter.


Kenneth,
The wires have a plug on them with a clip that needs to be released to pull out of the controller. Hope this helps.

Oct 07, 2015 | Pride Mobility Scooters

1 Answer

I changed the motor on my scooter MISSLE FS now the electric brake in the motor will not release? Can I get a wiring diagram 0f the scooter?


If thats a newer scooter..the module may not b recognizing the replacement. Mite need reprogramd..then u need a factory scanner. Rechec the installation first

Sep 15, 2015 | Electric Mobility Scooters

1 Answer

Rally scooter parts


The click sound is likely the electric brake releasing. If the brake is working and the scooter wont roll, then you engage it and you can push the scooter then you have a motor or motor wiring problem.
The Pride Rally is an older model whose electronics do not verify the motor is working prior to allowing the scooter to start. Please disconnect the motor wiring and check the motor's electrical resistance. It should read less than 3 ohms on a meter. If it doesn't, pull, clean and or replace the motor brushes if its a serviceable unit. If not - you may need a new motor - especially if the reading of the motor winding is over 3 ohms.

Oct 25, 2013 | Mobility Scooters

1 Answer

Aquasoothe Travel Lite. What caused it to fail?


hi, i have repaired loads of these scooters and it can be done cheaply as long as it not the motor, now there are two types the older type uses a motor to drive a gearbox attached to the wheel;, the other type is harder to repair is the hub wheel where the motor is located internally to the wheel...

£60 to be advised it the motor is shameful....I would n't charge that much for a fix !!!

Are you in the UK ?

Regards
Rob

Apr 12, 2013 | Mobility Scooters

1 Answer

Our Liteway scooter has been unused for a couple of years. We purchased a new battery and charged it up but it won't run. The freewheel device is in place and we've done all the troubleshooting we know per...


terry, did you replace both batteries? If you did check your wiring connections on the batteries. Make sure that the polarity of the wiring is correct( red to positive and black to negative) and if you replaced just one battery then you have to replace the other one also. Once you have 2 new batteries installed and have made sure the wiring is correct. Turn on the scooter and see if you still get the flashing lights look at your manual and see that the 3 flashes mean a short between the batteries and the motor. If you continue to get the error you will have to contact your local provider or a service company to check the scooter.. Hope this helps

Sep 28, 2010 | Golden Technologies Mobility Scooters

1 Answer

Will not go. ohm wiring all good, batteries are good, checked fusses good, replaced throttle pot assembly, replaced controller.checked motor with 24 volts it works.got scooter to move by playing with...


me tool time you checked or changed about everything but did you check the electric brake. Sounds like the brake is not working or is working intermittentaly. The controller needs to get the right reading from the brake or the scooter will not go and when you release the throttle the brake should engage immediately. I can't give you a well thats the answer but you should at least ohm out the brake. If you can call rascal Company on Monday and ask for tech support they can give you what the reading should be Hope this helps

Sep 18, 2010 | Electric Mobility Mobility Scooters

1 Answer

Can you replace a brocken axle shaft that goes into the scooter m


Hi. Why do you need to replace the motor? Very few motors completely burn out. Most suffer from stuck or worn brushes, and these can be fixed.
Some scooter companies will only supply the complete transaxle assembly, which makes it expensive.
What fault does you machine have, and how old is it?
Good luck. Neil.

Jul 11, 2010 | Golden Technologies Golden Liteway 3 Wheel...

2 Answers

Need service manual/parts schematic for Golden Companion II


hi ,I don't have access to the wiring diagram however I worked on most scooters so can I ask what the problem is , has the wiring loom got damaged ? if so please tell me the name of the motor contoller under the seat a blue or black box. I have rewired over 200 scooters so it not a issue. Not one failure.

Please let me know how you get on.

Regards
GeWiz.

Dec 29, 2009 | Golden Technologies Companion II Travel...

1 Answer

My farther as just bought a gainsbough 4 wheel


No, it means the Electro Brake is not engaging 100%,

Check the motor under the seat, now you will see two thick wires come from the motor , Red & Black if you look to the side of the motor you should see two thinner wires leading to the side of the motor , those are the brake power leads, (depending on Model) , has the brake seized ? or are the wires not making a good connection, these wire should lead back to the motor controller , normally a black or blue box, that is the motor controller , check connections, depending again on brand and model.

Regards
GeWiz.

Oct 16, 2009 | Pride New Mobility Legend 4 Wheel Scooter

Not finding what you are looking for?
Mobility Scooters Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mobility Scooters Experts

Robin Hill
Robin Hill

Level 3 Expert

1251 Answers

Colin Taylor

Level 2 Expert

340 Answers

wcdoc1953
wcdoc1953

Level 2 Expert

269 Answers

Are you a Mobility Scooter Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...