Question about DVD & Blu-Ray Players

1 Answer

How to open back cabinet to portable player, sony dvp-fx820

Can you please tell me how to open the back cabinet to this? I have removed all screws and it will not open up. It seems hooked at the front corners. Thanks!

Posted by on

  • leighanna23 Nov 03, 2008

    sorry, forgot that part. It is the DVP-FX820

  • leighanna23 Nov 03, 2008

    Thank you!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,594 Answers

Would you like to mention model number of your Sony dvd player to provide you help.

Posted on Nov 03, 2008

  • Shahid Electronics
    Shahid Electronics Nov 03, 2008

    Hi,
    Please see below exploded view and find all screws need to be open back cover.




×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

DVD tray will not open on my Toshiba DVR620KU


Googled this for two days with no success! Finally, out of despiration I took the screwdriver to the top cover. (four screws in the back, and two screws on each side) Lifted up the rear section of the cover which the released the front for removal. The input pc board is right on top of the dvd tray so little could be seen, so I removed the screws and clips holding the pc board. Make sure that you you disconnect the power before doing this however. Once you have removed the three screws, (two of which have attached grounding clips) you will need to disconnect the HDMI cable which plugs into the back of the board if you had not already done so. Now carefully plug the unit back into ac power, and while holding the board in your hand careful not to allow it to touch anything,press the open button on the front of the unit, and as you move the board slightly while pressing the button, the tray mechanism will start to try to release. Press the button several times till the tray opens completely and stops. Now comes the tricky part: Unplug the AC power plug while the tray remains open. (Otherwise the tray may close again and you'll have to go through the wiggle routine again to get it to open) Once it is open, remove the DVD Disk if there is one in there. OK, so now if you have followed these instructions so far the tray is open and empty, and there is no power to the unit, you can begin reassembly. Put the three screws and two clips back into the PC board loosely at first till you have all three started, then proceed to tighten each one. Replug the cable into the back of the PC board and then replace the top cover and the screws following the same procedure. Plug the unit back into the AC receptacle, and turn the unit on, then press the open/close button, and the tray should open and close as normal. I think what caused the problem to begin with is that I had left a DVD disc in the player for an extended period of time in the start play mode, and it either jumbled the programming or damaged the disc. I have not tried to put the original disk back in the unit to find out! I want to use it for awhile first!

Jul 10, 2012 | Toshiba DVR620 DVD Recorder/VCR

1 Answer

Brand new sony portable dvd player dvp-fx820/p's motherboard got damaged according to sony people, it was an accident by my daughter she was drinking her apple juice and accidently a few drops just...


Liquid and Juice though incompatible with electronics (don't mix well) are
not always deadly. BUT you do need to gid rid of them completely. First
off, remove the unit battery and do not apply anymore power to it (via
the AC adapter). Because any liquid can easily find its way inside your unit,
(unseen to the naked eyes) you may have to have someone with electronics skills
taking it apart and using a soft tooth brush dipped in fresh water and removing
the sticky sugared liquid completely. Shake the board to get rid as much of water
from it and allow it to dry for a day. I have fixed many electronic devices
successfully this way.

Jul 15, 2011 | Sony DVP-FX820 DVD Player

3 Answers

VUP 0/9 KEEPS FLASHING DURING FIRMWARE UPGRADE NOW ITS MORE THAN ONE HOUR


I had the same problem when I made the mistake of trying to do a firmware upgrade via CD-R instead of the Network option. My player is no longer connected to the internet so I created a CD-R following the directions on Sony's site. The CD-R attempted to do the upgrade, but was stuck at 0/9 and I could hear the disc trying to read. The problem is the disc you created. You need to make another one. On the Mac, I used the Finder to burn the disc per Sony's instructions. That is what failed in the player. My second CD was created with Roxio's Toast Titanium, PC/Mac Data CD-R. If you have Windows, I would suggest using a commercial burning CD program, like EasyCD Creator and burn the two update files to the root level of the CD. Make sure the disc is finalized.
Next, you need to open the player to manually release the tray to eject the CD and swap it with your new disc. Remove the two back screws on each side. This removes the two side trim panels. Remove the two screws holding the top trim panel on each side. Then slide the top trim panel from front to rear to release the panel. If that doesn't work, open the CD cover door with your finger and then gently pull up on the top panel at the front edge to release the clips along the front, across the entire front edge. Then slide the panel back to remove it. Then remove the three screws at the front edge, and two more screws on each side. There is also one screw at the rear top edge. Remove the top panel. Then get a long paper clip. Looking at the front of the player, the manual eject hole is on the right side of the optical drive. Above the hole is an E engraved above the hole. Insert the paper clip straight into the hole and you should be able to push the release mechanism causing the tray to open. You might have to fish around a little. Slide the tray open and replace the disc with the newly burned disc (or obtain a disc from Sony for free through their website). Close the tray. You can leave the player open. Plug in the power cord and the upgrade will continue where it left off. It may take a minute or two, but you will see the VUP advance to 9/9, then finish. The tray will open and you can remove the disc. Close the tray and the player may reboot again. Once you see the No Disc message, turn off the player and pull the power cord. Reassemble in reverse order and reconnect your player to your TV and it will have the new firmware.

Oct 04, 2010 | Sony BDP-S550 Blu-Ray Player

1 Answer

Will not turn on is there an internal fuse ???


Yes. Remove the screws that hold the cabinet in place - 7 of them, 3 on back, 2 on each side. The board to the left of the drive, from the front of the unit, has the power cable and on/off switch attached. On the right front of the board is a fuse - F2AL 250V. Mine blew out and once replaced, unit worked fine. Had the unit for 4+ years and moved it all over.

Aug 14, 2010 | Apex Digital AD-1200 DVD Player

1 Answer

Our DVP-FX820 DVD player is 16 months old. You can hear the sound when it plays but can't see a picture.


Please try adjusting the backlight. If the issue persists, try resetting the player. To reset the Portable DVD Player, remove the battery of the DVD Player, then reconnect it after 1 minute and check if it helps. If the issue still persists, then the player requires service.
you can get the unit serviced at:
https://eservice.sony.com/webrma/web/index.do

Jul 21, 2010 | Sony DVP-FX810 Portable DVD Player

1 Answer

I dropped my Sony portable dvd player (7") about a foot, it will no longer recognize any dvd?


Hello steve, your dvd player lens be dislodge or parts have been damage and may need reallignment, I dont see how we can do this, this needs service by sony.

May 11, 2010 | Sony DVP-FX820 DVD Player

Not finding what you are looking for?
DVD & Blu-Ray Players Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top DVD & Blu-Ray Players Experts

kakima

Level 3 Expert

96372 Answers

The Knight
The Knight

Level 3 Expert

68157 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a DVD and Blu-Ray Player Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...