Question about Pride Jazzy 1650 Heavy Duty Power Wheelchair

1 Answer

Battery wont take a charge

We have a jazzy model #1420 and just recently out of the blue the battery will not take a full charge. it does not charge any higher than 6 lines (4 red & 2 yellow). any hints?

Posted by on

  • Anonymous Feb 04, 2009

    i charge the chair and the red light keps blinking and it does not get a full charge

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

How long you using this battery? Tighten your cable battery terminal and charger connector.

Regards,

mas Didiet

Posted on Nov 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pride jazzy 1113, controller light scroll back and forth, wont move, i bought one new battery, it has full charge other battery is a little over 10 volts. is there way to test charger with volt meter?


The voltmeter should read 29 volts when on. You should never replace one battery and leave an old battery in the chair. Replace them both at the same time.

Oct 17, 2013 | Pride Jazzy 1113 Power Chair

1 Answer

My wheelchair shows full charge, 2 hours later, it is blinking and out of charge. This happens while I am at work and just setting at my desk. We had batteries tested and they are fine.


Pride has a problem with a battery cable that will draw down the batteries like you say just sitting there and I'm not sure if it is with the Jazzy 1113. I would contact Pride @ 1-800-800-8586 ask for Jazzy Tech support and explain your problem. They should be able to tell you more specifically what the problem could be. I still think the batteries can be a cause of your problem but the Jazzy folks can help Hope this helps

Mar 19, 2011 | Pride Jazzy 1113 Power Chair

1 Answer

How long does it take to charge jazzy select gt


Mike it depends on the charger and how discharged the batteries are. But if you get into the habit of charging it overnite when you get up in the morning it should be good to go. A 3 amp charger will take longer to charge than a 4 amp or 5 amp. Now if you are charging overnite and still don't get a full charge then you could have battery problems ie one weak battery causing the chair not to get fully charged or it could be the charger but if the charger has been doing ok in the recent past then I would have to suspect the batteries Hope this helps

Feb 19, 2011 | Pride Jazzy Select 6 Indoor Power...

1 Answer

The jazzy 1113 will not start, when you press the power button the speed light comes on gets full and then turns back off


How old are the batteries? If you've had them for a few years it might be time to change them. Even if batteries are charged correctly they eventually lose power with use and need to be changed. Here is a link to the battery needed for the Jazzy 1113 http://www.replacementupsbattery.com/UB12350-NB.html

Nov 08, 2010 | Pride Jazzy 1113 ATS Indoor Power...

1 Answer

When charging my jazzy, do I unplug any plugs that controls my jazzy, or leave all plugged in? the reaon ask, green light will not come on the charger, which is onboard charger, unless I unplug controller...


No JJR all the plugs need to remain plugged in. On the Pride chairs the light on the charger will only come on green when the batteries are fully charged. When you unplug the controller the charger thinks the batteries are fully charged and the light comes on. Now the problem is the batteries. If they are old or you have a bad battery then the charger never senses a full charge so no green light. Hope this helps

Aug 26, 2010 | Pride Jazzy Select 6 Indoor Power...

1 Answer

Charge wont hold long


Usually that means one of the two batteries is bad. The charger will indicate the full charge of the good battery. Have the batteries load tested at your local interstate battery or autoparts store. May need to replace only one battery. It is recommended both be changed at same time though.

Jun 13, 2010 | Pride Jazzy 1113 Power Chair

1 Answer

Jazzy 1113 ATS Indoor Power Wheelchair: the battery is fully charged but it wont move does...


Hi. Your machine probably has a fault, but I very much doubt that it needs reprogramming.
Are the free-wheel levers in the correct place? Is the machine displaying any fault codes, e.g. flashing LED's and what is the pattern or number of flashes between pauses?
Good luck. Neil.

May 16, 2010 | Pride Jazzy 1113 ATS Indoor Power...

1 Answer

Jazzy select 14 won't charged - have replaced batteries


At a minimum your batteries need to be charged for 12 hrs a day for the first month if not they will not build the capacity and will dwindle and die for example it is at only 25% capacity it says it fully charged but will die quickly this happens because it is charged to its full capacity but that is only 25% of the batteries true potential resulting in short battery life. Also the new batteries need to be charged before they are put on your jazzy. Then its a matter of if not in use put on charge. I think you need to have a word with your dealer.

Oct 06, 2009 | Pride Mobility Products Jazzy Select 14

Not finding what you are looking for?
Pride Jazzy 1650 Heavy Duty Power Wheelchair Logo

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pride Wheelchairs Experts

Colin Taylor

Level 2 Expert

340 Answers

wcdoc1953
wcdoc1953

Level 2 Expert

269 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Are you a Pride Wheelchair Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...