Question about Technics SL-MC70 60-Disc CD Changer

1 Answer

CIRCUIT DIAGRAM Please let me know where I can get a hold of a circuit diagram for this model?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

Try this website..partstore.com

Posted on Nov 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiring diagram for kenwood cd recievers


Hello again Bob,

Searching on pin-out, circuit drawings or schematic ought to get you there... Most the sites I referred you to yesterday still remembered your 97 Celica GT from my previous searches...

Yesterday I forgot to invoke "PRIVATE"... SO I'll be WADING in Celica Adds & ACCOUTERMENTS for a few daze...
(un- CLOAKED)

Happy hunting.

KENWOOD USA

need the pin out diagram for Kenwood CD receiver KDC 128 Audio Car CD...

Your search for kenwood cd receiver returned the following

Mar 04, 2016 | Kenwood CD Players

1 Answer

Still does not tell me where the internal battery is on the WD450 Wurlitzer.


The battery is located on the circuit board just behind the disk drive. Open the butterflys, remove the two screws from the rear that hold on the top cover. Slide to top cover towards the front of the keyboard. Unfortunately the battery is soldered onto the circuit board.

May 05, 2013 | CD Players

1 Answer

I dont know to to connect in ford explorer


what make of stereo and what year explorer please ill send you the diagram

May 07, 2012 | Pioneer CD Players

1 Answer

Marantz CDR510 Display is blank


If that is the case there is a missing B+ line to the display, you will need a circuit diagram to find the fault.

Mar 13, 2012 | Marantz CDR510 2-Disc CD Recorder

1 Answer

Sony CFD-RG880CP, can't get the demo mode off. I have followed the user instructions, but the machine keeps on blinking. Annoying. The only way to get the demo mode off is to take the power cord off the...


This drove me crazy too! The instructions are WRONG!
With the unit plugged in, but NOT powered on do the following:
You have to press and hold the DIPL/Ent button ON THE UNIT, and while holding it, press the STOP button ON THE UNIT, which is the LARGE button CLOSEST TO THE RIGHT EDGE OF THE UNIT. The diagram they show is pointing to the PLAY button- WRONG WRONG WRONG!
Hope this helps others

Dec 25, 2009 | Sony CD Players

3 Answers

Manual for the NSM Prestige E160 and circuit for 76M amplifier


Hi,

If you send me your details I will scan my circuit diagram for the 76M amplifier. I do not have the manual but I do have a list of the programing locations.

Regards
Alan Hood
ami-man
UK
alan-hood@datex.co.uk

Jun 04, 2009 | Wurlitzer Jukebox CD Player

1 Answer

CDP-CX355 cd player


Hello,
You can have service manual of CDP-CX355 from Manual Zone and Service Manual net

Regarding test and checking of audio out circuit, service manual will help you a lot and let me know do you get distorted sound in digital out or analog out.
If its analog audio out, then IC401, 402 and IC302 on main board are suspected. (see below picture, part of main board)
Need further info / help, let me know to guide you further.
Thank you.

1bdbc92.jpg

Dec 14, 2008 | Sony MegaStorage CDP-CX355 300-Disc CD...

1 Answer

One more time vinyl wurlitzer juke


Assuming I am looking at the same diagram for a 'Compact' amp....the circuit you are looking at is unrelated to GL1.

The two diodes rectify 10VAC from the transformer to a rectified +12V DC which supplies the mechanism. To blow both diodes I can only assume that you have a dead short to ground or -Ve somewhere.

Check both diodes and fuse are good with the mechanism plug disconnected. You should get 12vdc at the cathode of the diodes.

I don't know about the diodes you are using but 1N4001 or 1N4002 or 1N4003 should work fine.

The 12VDC comes out on pin 2 and pin 4 of the mechanism plug. Make sure the diodes are the RIGHTway round or you'll end up with MINUS12V.

Dave.

May 17, 2008 | Wurlitzer Jukebox 1015 One More Time...

1 Answer

Aiwa nsx k570


i need the circuit diagram for the CD player in NSX K 570 Aiwa 3 CD changer music system . I am Located in mumbai colaba. 9819890987

Mar 18, 2008 | CD Players

1 Answer

Need installation of cd-RW880


Try it yourself! Let us know what you are connecting(make and model of everything) and someone will help you with a diagram.

Aug 16, 2007 | Teac CD-RW880 CD Player / Recorder

Not finding what you are looking for?
Technics SL-MC70 60-Disc CD Changer Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Technics CD Players Experts

Josh Whitehead
Josh Whitehead

Level 3 Expert

1146 Answers

The Knight
The Knight

Level 3 Expert

68197 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Technics CD Player Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...