An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert that has over 500 points.
Re: in RCA T13208 13 in. TV/VCR Combo shut down after...
The safety circuit is sensing a problem and is why it will not let the tv stay on,the cause could be a problem on the mechanics of the vcr,you need to get an estimate to see if it is worth the repair and might be able to keep using just the tv.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I don't have a code book for you, but I can tell you how to program the RCR660 using the automatic programming feature.
Programming RCA model RCR660 (no code search button) While following these instructions, keep the following in mind: device = the component you wish to control with your remote (TV, DVD, VCR, etc.) DEVICE = the button labeled for the component you wish to program 1. Turn on the device you wish to program. 2. Turn off all other devices in the general vicinity. 2. Press and hold DEVICE 3. While holding DEVICE down, press ON/OFF and hold them both down until the LED turns on for that device. 4. Release both buttons. 5. Point the remote at the device, press and release PLAY and wait 5 seconds or until the LED stops flashing. 6. If the device does not turn off, then continue to press PLAY and wait the required interval (for a maximum of 20 times) until the device turns off. 7. When the device turns off, press REVERSE, wait two seconds and continue doing this until the device turns back on. 8. To finish programming, press and hold STOP until the LED turns off.
It sounds to me like you have a problem with the reel sensors not detecting movement of the tape through the VCR. This could also be caused by a defective voltage regulator(s) that powers the sensors. This model was made by symphonic/funai (1-800-242-7158), and it is not likely worth repairing.
You have with this set whats know as a regulator problem. Since there are no user serviceable parts in this set im sorry to say your gonna have to take this set into be serviced unless you under stand television circuits. You will need a service manual and a good multi meter and monitor the output from the regulator IC . If it fluctuates all over the place replace it. If it dosent then its in the regulator driver circuit. Good Luck