Question about Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
I found that the rubber seal on the bottom of my cyclone is not properly seated to the bottom of canister, I guessed when I removed the clear canister bin completely from cyclone unit for cleaning, I put the cyclone down on the floor and rubber seal accidentally move upward just a little. this creates a small gap on the bottom when I reassembled it, (since seal is up from it original position a little). I pulled rubber seal down to its original position, you will notice that there should not be a gap on the bottom at all, this way you do not have to clean or should not have to clean the filter but once a month or even less.
Posted on Aug 14, 2009
I've had this problem as well which started for me after using the Dyson to clean up a pile of confectioners sugar my son dumped out. Various nooks and crannies inside the Dyson became clogged causing irregular behavior of the vacuum. Clean the cyclone as others have suggested but also get inside the cyclone for a more thorough cleaning. There are 3 hex screws by the handle, remove these and take the handle off. You can now see the tops of the cones which for 4 were completely caked with sugar. Scrub each cone out good and blow compressed air in each to really blast out the clogs. Take off all other removable piping and clean thoroughly. This should return the unit to its regular operating state and hopefully stop debris from making it through to the filter. Hope this helps.
Posted on Feb 01, 2009
It sounds like the cleaner hasn't been reassembled correctly after emptying. I would have to look to give a definite answer or check with Dyson.
Posted on May 07, 2013
If you are getting dirt, hair, debris, etc. on your filter it is because of the rubber ring at the bottom not being seated properly. It took me buying a new filter and it getting clogged after a few swipes to figure out. Wish I would have seen this earlier!
Posted on Jul 06, 2010
Hi if you turn vac over and look at the cover that hides the brush roller and remove the cover ? it is held by nylon twist 45 degree left type screws ? then you may find the brush housing clogged as well as the channel flow tube below the brush ? lift brush out and release from belt to enable to clean of hairs/carpet strands etc ? then reassemble next remove the clear canister and clean you will then see the cone/air filter ? it has hundreds of holes that get clogged due to vacuum created in cyl use a small implement and poke every hole clear ? if these are clogged vacuum remains in operative resulting in no vac at pickup head/brush beater roller assume you have replaced the disposable filters? hope this helps not an uncommon/fault and easy remedy
Posted on Oct 31, 2008
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Jun 28, 2014 | Hoover Vacuums
Jul 08, 2011 | Bissell Vacuum - Momentum Cyclonic 1 ea...
Nov 13, 2009 | Filter Queen Majestic Canister Vacuum
Aug 26, 2009 | Vacuums
Apr 14, 2009 | Vacuums
Jan 03, 2008 | Hoover U5507900 Elite Rewind Bagless...
Oct 13, 2007 | Eureka 431A Optima Bagless Upright Vacuum
2,545 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: