Question about NEC PC Desktops

1 Answer

I think the motherboard has blown - NEC PC Desktops

Posted by on

  • el_grizo Oct 31, 2008

    do you know where i can get a motherboard for a NEC Versa S3000 laptop? it seems kinda rare



×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 67 Answers

You might have to get a new one

Posted on Oct 31, 2008

  • knvosss Oct 31, 2008

    no, but you should try to give a little more info when you post, your question was very vauge

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Motherboard capacitors blown


Replace the blown capacitors with new caps with the same value and voltage rating. These caps will be polarize caps and need to be inserted on the motherboard in the correct orientation.

Oct 02, 2012 | HP Pavilion a6720f PC Desktop

1 Answer

I got a dell precision 380 has a green light on motherboard but not switching on


i think you dont have proper power coming try to stabilize the power and try changing the ram slots if this does not work then i think you have blown your motherboard

Mar 17, 2010 | PC Desktops

1 Answer

No power. Computer will not turn on. I have relaced the power supply but this did not change anything. Could it be the motherboard?


It could definitely be your motherboard. It can also be a faulty CPU, but that's uncommon.
Check if you see any blown capacitors, especially around the CPU area. A normal capacitor has a completely flat top. A blown one has a dome...

BUT, I would begin with the next simple test:
Unplug the power connector from the motherboard, then short the 2 pins it sat on using a metal tool (eg. a screwdriver). If the computer turns on - it's a problem with the power button on the computer case!

Mar 14, 2010 | PC Desktops

2 Answers

EMachine T2482 Computer won't power on or boot up.


Try removing the power cable from the power supply. Wait 10 seconds, and replace it again. Try powering up the computer. If it doesn't power up, check that the motherboard has power (there should be a LED on the board which is lit up. Of course, check the fuse also in the plug.

If the LED is on, you have a failed motherboard / Switch. If the LED is off, then you have a failed power supply. Beware though, if the PSU has blown, it could easily have taken the motherboard with it.

Mar 14, 2009 | E-Machines T2482 PC Desktop

2 Answers

I have a gateway 835gm desk top


there are a number of things that could be wrong here, firstly reset the cmos on the motherboard, if you cannot find the cmos jumper then remove the battery for 10 minutes (make sure the power cord is removed from the back) press the on/off button a couple of times, this will drain any remaining power from the board and properly reset the cmos, while the battery is out remove the memory, clean the contacts and repace, put the battery back in and connect power, if the machine turns on, job done, if not then it could be something far more serious, check the power suppy if could be faulty, the processor may have blown or the motherboard itself may have blown, the only way to check all the components at once is to get a working motherboard which supports your processor type, the same model would be an advantage

Nov 15, 2008 | Gateway 835GM (835GH) PC Desktop

3 Answers

PC has died !! I've disconnected all the HDDs, ROM, RAM, Video Cards and still dead. Power light comes on, CPU fan starts up, NO LIGHTS anywhere on the motherboard, two short beeps, followed by third beep....


based on your information the two beeps is an indication that you motherboard is alive and looking for a memory. is the video integrated or you use a separate video card? i think this has something to do with your video. if your video is integrated try putting in a video card

Jun 19, 2008 | PC Desktops

2 Answers

GATEWAY DDR MOTHERBOARD


I don't think it is the chip, or the motherboard, do you know if the hard drive is still good, cause if it isn't it will also cause this to happen.

Feb 16, 2008 | Gateway GT4022 PC Desktop

1 Answer

Emachine W1135


when ur starting the tower and it light are on and ur fan there is no problem with the power supply, i think that u rily need a new motherboard because ur board will not boot on start up..

Oct 17, 2007 | AMD eMachines Desktop System w/ 17'' CRT...

3 Answers

Uncontrolled CPU fan speed


Make sure you have used the proper Fan connection on the motherboard and that you used all the pins in it. Usually it consists of 3 to 4 pins for CPU fans. Does your Fan have 3 pins? If not then it is not compatible for Fan Speeds. Also check your BIOS for Fan adjustments. Hope this helps.

Sep 15, 2007 | HP Compaq d530 SFF PC Desktop

Not finding what you are looking for?
PC Desktops Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top NEC PC Desktops Experts

isaac johny
isaac johny

Level 3 Expert

796 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Abhinandan  Patil
Abhinandan Patil

Level 3 Expert

562 Answers

Are you a NEC PC Desktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...