I have a problem with the Tally T6100. I want to print a formular which is 12 inches of 33cm. In my settings of the printer I don't have a setting to print it. There is just German Std Endlos and A4 and so on, but a setting which 12 inches/33cm ist not available. Could someone help me?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
THe T6215 can only print a maximum width of 13.6 inches.
If you create a form wider than this Windows will not allow you to select this form within the printer driver as the printer is not physically able to print this wide.
Your paper may be 15 inches wide but it is unlikely you will be printing 15 inches, simply create a form whose width is equal to the maximum print width or 13.6 inches.
You will then be able to select this form in the printer driver.
you need to create a forms for your specified paper size. 1.open printer and faxes in win xp. 2.file...server properties...create a new form(check) 3.type a name for forms 4.type a size in below boxes...(like 10 x 12 paper , width is 10 inch, height is 12 inch) 5.save it 6.close 7.rht click the printer...device setting tab... select a form name in the tray . 8.it will work
horizontal or vertical characters missing???
if your missing horizontal lines, look at where the print is missing if you see imprints... u have bad ribbons.
if your missing vertical characters down the page
Power off the printer & unplug from wall
Remove with phillips the top right cover. u will see that the control panel has a plastic clip needs to be pressed in for the control panel to come loose from the top right cover.
Then you will see P703 Hammerbank Ribbon Cable and P704 Hammerbank Ribbon Cable swap these 2 cables on the Engine Controller Board part# 083368.
IF your missing characters move to another place on the printout then u will need to replace part# 083368.
IF your missing characters are still in the same place, then you will need to replace hammer module part# 081152, their is qty 11 of the individual 081152 about 1 inch wide. this will save $$$ ordering and replace 081152 if you have some at your work semi technical.
Be very careful with hands when powering the printer with the top right cover off Electrically and mechanically. Need more help you may call Toby at x311