Question about HP Compaq ProLiant ML530 Server

2 Answers

HP Proliant ML370 Server: Very Urgent Please

Booting a Hp Proliant Ml 370 Server which gives beep sound while coming up and does not transmit to the monitor.

When you turn the server on,It tries to pick but after a while it drops and then the sound comes on, its a beep sound but longer than that of a memory error sound.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 61 Answers

Open the system cover and check whether any LEDs showing amber or Red colour

Posted on Oct 31, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

DA maikuna...........................

Nee eppozhada server kandu thudangiyathu,,,,,
Nee aare problam solve cheyann,,,,,,,,,,,,,

Regards,
Raphi

Posted on Jul 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Compaq Proliant ml370 g2 does not boot, beeping every 30 seconds, no video output. Internal Health LED is RED, Harddisk Health LEDs all green Component Health LEDs all green (RAM Banks are...


hdd fault caused by surge video card failure ram failure hdd failure depends what the beep codes are they are coded the length and duration tells you what the fault is ie three short beeps or two long ones try bleeping computer.com or check out bleep codes
http://h30499.www3.hp.com/t5/ProLiant-Servers-ML-DL-SL/Proliant-ML370-G2-server-strange-beeping/td-p/3221528#.VJgYMsgDQ

Apr 28, 2011 | HP Compaq ProLiant ML370 G2 Server

1 Answer

HP Proliant ML 370 G3 the server is got hung intermediatly. Please provide assistance.


Check if the processor fan is running properly. Also check the RAM modules, as these could sometime cause the machine to hang.

Jul 08, 2009 | HP Compaq ProLiant ML370 G3 Server

1 Answer

It wont restart with a new IP address. Goes back to old one.


Hi there pls confirm whether you have tried to uninstall the network adpter and then restart ,or if physically the network adpter is installed in the PCI slot then change the slot and then reinstall I think this should workout or else the firmware for the server can be obtained frm HPupgrade with all the precaution as mentioned

Jan 20, 2009 | HP ProLiant ML370 G5 Server

1 Answer

Problem with scsi driver proliant ml 370 for NT4


Are you attempting to boot from the Windows CD?

If you are booting the server from a Windows installation disk and it is unable to detect the hard drive, this typically means the following things.
You need to provide the driver for the RAID controller of the server (this can vary, depending on the version of the ML370 e.g. G4/G5)
If it still cannot detect the hard drive after providing the driver for the RAID controller or if there is not a driver available for NT4, it may not support the controller.
In this case you can remove the RAID set by entering the RAID setup (could be LSI or adaptec). NOTE THIS WILL DESTROY ALL DATA ON THE DISKS THAT ARE A PART OF THIS RAID SET.

Dec 26, 2008 | HP Compaq ProLiant ML530 Server

1 Answer

HP Proliant ML370 Server: Led shows red light


Hi there,
Your server definetly has issue booting first of all this is a little old server model so first open and blow air from a blower (&not use vaccum cleaner)
since problem could be anything frm a struck cpu fan or anything
then poer donw theM/c and locate the RAM its a smal hardware in green color vertically fitted to the motherboard it will have locks at the both ends press them downwards the RAM will pop out then clean the side that was inside the motherboard with eraser and nothing else(it might damage the RAM) then fix it as it was aligning the notch it should work

If this does not work out then tell me exct LED and sybol near it
Bye for Now



Nov 03, 2008 | HP Compaq ProLiant ML530 Server

1 Answer

HP Proliant ML370 Server i have problems solving this server problem. When you turn on the server it tries to initialize and come up. But after a while it gives a beep sound, this sound is like that of a...


Remove all the cards except dispaly from the slots,disconnect all  hdds and start the server in minimum hardware and check.reset bios .Is there any LEDs in the mother board is glowing amber or red colour??Please try these diagnostics.

Oct 29, 2008 | HP Compaq ProLiant ML530 Server

Not finding what you are looking for?
HP Compaq ProLiant ML530 Server Logo

Related Topics:

1,186 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computer Servers Experts

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18297 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a HP Computer Server Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...