Screen imprint Bought 13' tv and did not receive remote. Picture is perfect except for channel imprint remaining on centre of screen in big red numbers. Is this a problem that can be remedied with the remote or is service necessary.

You will need to get a "regular" Universal remote and program it for that particular model of TV. You will need to access the on screen setup menu for the TV and then have it scan the channels. Make sure your DTV box is on and connected with the coaxial cable. If the "TV Input" button on your DTV remote works and you can get it onto the Video Channel, You can connect your DTV receiver with the RCA Cables (Red, White and Yellow) and get your picture that way. If you access the on screen menu, you will need to scan for Analog and Digital channels as the receiver transmits in Analog. hope this helps.

dana_derek,

The TV is not on the correct input setting or channel. Depending on your TV model and the receiver, you have a cable coming from the receiver to the TV. That cable could be a coax (screws in), RCA (yellow, white, red tips), component (green, blue, red, white, red tips), or HDMI cable. For all cables except the coax, the TV should be on an input setting. With your TV remote, you should have a source, input, or TV/Video button. Press that button and it should bring up a list of input settings. Each time you press that button it will scroll you down the list. Try each setting until you find the picture. I hope this helps.

Ray Calo
DISH Network

Have you tried hitting the format picture button on your remote control. Seems the picture is in zoom mode. If you have a cable box for HD Channels then look on the remote for a button (format) or Screen size.

sounds like a defect. if you gought it recently, i would return it. there is nothing to repair that.

try re-botting your HDbox,also refit your scart lead to your box & t.v.
If you drop me an e-mail I will go through how to re-bot your box,if you don't know - re-botting your box helps pull in all the new software for your box - think it like a pc needing to update the programmes.
e-mail [email protected].

I had the same problem with the same unit when I first bought it a few months ago.

First up remove the DVD. If the TV stations do not appear within a couple of seconds press the "TV" button (top, second from left) on your remote control.

Let me know if this doesn't work.

Reset the aspect ratio/ picture size from your remote or from the menu.

Invest in a long poking stick....... Either the Infrared receiver or controller it blew out. The high amount of static electricity formed and must of jumped off by the infrared receiver causing a momentary short in the circuit board. Safety's shut the tv down before frying, but damage looks to be done. It can be fixed, but only cheap if only the infrared receiver was damaged, anything else and it's going to be pricey. 

Just bought a new remote for my VS60603, then main board goes bad upon moving to new location. Never used it. Interested in purchasing it? Email [email protected].

We have a Sylvania 6313CB TV/VCR combo.  I bought a universal remote and the code would not work when I tried to program it to the "TV" button using all those possible codes listed in the books.  So, on the universal remote, there was a button named "VCR" and when I programmed in the code "0000" all worked.  This was a $6.00 universal remote named "One For All"  we bought at the Big Lots store.  
Specifically, here is what I did:
Turned TV on Pushed the "VCR" button and light blinked once Pushed and held the "set" button until it blinked twice Released the "set" button and entered the numbers "0000" Pushed the on/off button and it worked including volume, channel up/down and channel change by entering the channel number.
Hope this works for you too.