2001 Jeep Grand Cherokee won't Turnover

Transmission sticks in reverse- won't go into park. - JeepsUnlimited

www.jeepsunlimited.com/forums/showthread.php?...won-t-go-into-park
Jun 14, 2013 - 12 posts - ‎5 authors 2003 6 cyl 4x4 Grand Cherokee Laredo automatic- Occaionally, when shifting from REVERSE TO PARK, my Jeep will stay in reverse. Typically its ... '2001 WJ'4,0L'42RE'NV 242'380000 km'ECE Compliant' ??????????? ??? ...

2001 jeep grand Cherokee laredo - CarGurus

www.cargurus.com > Questions > Jeep > Grand Cherokee
CarGurusJan 27, 2014 - 2001 jeep grand Cherokee laredo - Just purchased a 2001 Jeep GrandCherokee Laredo and ... It starts in PARK sometimes and sometimes it won't and I have to start it in Neutral. ... Hatch shuts flush, but won't stay shut. help!

Your starter solenoid armature is sticking. It is mounted atop the starter and the heat from the exhaust manifold sometimes causes this problem on older systems. You can try a temporary fix by placing some type of heat shield over the solenoid using something that is fire proof but replacing the solenoid will eventually be necessary.

Could be a failing starter or problems with the cables.
A dead cell in the battery will do it too.

change the wires that go to the starter i had the same problem fixed now with no problems

Not aware of any re-set on Jeeps. But you said it won't crank? Starter is not working? Please clarify.
If it won't crank over from the starter, your problem is in the start circuit, and not affected by fuel pump operation. So, please reply.

Bad crank sensor or main ecm needs repair.

Chrysler products are notorious for the crankshaft sensor going out and causing the symptoms you are describing. It also won't set a code to turn the check engine light on.

Your starter solenoid is going bad. You can either replace the soleniod on the starter or replace the entire starter assembly.

G'day mate , my best tip would be to take it back to the electrician, reason is that on a complex set of systems such as a motor car when one "weak" part is replaced then the next weakest one will show up, its a process of elimination not a quick fix , give the man a go as he is highly trained ( we would hope ) hope this helps

Replace the terminal end ,with a new one that fits tight.