Hotpoint first edition takes in water but does not wash

fit new door interlock switch not too expesive parts about £15

sounds like you have a faulty water valve its on the cold water side if you replace both then you can not go wrong make sure you put the two set of wires onto the the valves the way you took them off good luck

water level is determined by the pressure system, and no adjustment can be made.Ensure your programe is not selected to half load.

Could need new motor brush kit>

mine was doing the same it was the bearings

Try unplugging the unit and plug it back in. This may reset the controls.

Suspect motor brushes need replacing.
Simple task accessed by removing the top of the washer and releasing the clips holding the brushes into the motor - clip on back of brush - to remove the brush assembly.
Replace complete brush assembly.

hi there maybe your waste pipe might be blocked from washing machine or mqaybe there is a blockage somewhere else in your plumbing which does happen queit alot? hope this helps

hiya
first off norah, you will need to check the pump filter as there is probably a blockage in there.

secondly guest, sounds like a faulty pressure switch or even a small hole in the pressure pipe, thats why your machine will not stop filling.

hope these help

please dont forget to rate the helpfulness of this reply thanks kj

Just leave that concrete block there, it is to prevent your tub from taking off skywards.