Question about Polaroid TLA-01911C TV

1 Answer

Wont power up - Polaroid TLA-01911C TV

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Polaroid Master
  • 6,993 Answers

Hello,
The issue you describe is consistent with a power supply board issue. This is the board where the AC goes to. This problem may have occurred as a result of irregular power supply, or excess power supply or power surge.
The TV is receiving current but cannot circulate or transfer the current to other necessary part of the TV because of the defective power supply board. You might be lucky it's just a blow fuse. Also a defective transformer can cause your TV not to power on.
All these can be checked on the power supply board.
But more often bad capacitors causes problem on the power supply board. I do not think the power board needs replacement, rather those defective capacitors is causing this issue. Open unit up and take a look at the power supply board.You will probably see one or more electrolytic filter capacitors that are bulged up in the top-not perfectly flat like the others.
The value of these capacitors will be different, most likely they will be somewhere around-820 to 2200uF/25 V( or /10V sometimes)
You can replace them with same values but I would recommend the voltage rating to be higher(like 35V for an original 25V) for reliability purposes.
What happens is,these bulged top capacitors will cause a low and unfiltered DC voltage=main board will malfunction(the relay will keep clicking until the caps are holding enough charge to bring the voltage up over a threshold point).
You can buy these capacitors at any Fry's or Radioshack store or you can order them online at vendors like "mcmelectronics.com"(look for electrolytic capacitors). After replacing these capacitor(capacitors) most likely the normal operation will be restored. Or you can by a refurbished complete power board to save you some stress.
Note: There may be also some other causes for this symptom ,like a defective T con board ,or main board,but the bulged top capacitors are the most common cause for this issue.
If you don't know about TV repairers, take the TV to the nearest repairman to fix the fault for you. Also, note that TV stores a lot of current, so wait a while before opening the TV back cover.
I hope this helps.
Regards

Posted on Feb 24, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My packard acer wont turn , power light comes on when pluged it , but wont power up


Packard Bell, Acer? Which manufacturer? Remove the power, remove the battery, remove hdd and RAM. Plug in the power supply and press On. It will complain that is has not any RAM etc. If it does, insert one RAM chip and try again gradually if not you have a motherboard issue.

Oct 05, 2016 | Acer Computers & Internet

1 Answer

My rci2980wx wont power


the diode is located near power cables and trace from power switch, the diode is quit big and something like IN4001 to 6 Re: Jeff

Dec 01, 2012 | Radio Communications

1 Answer

My automatic windows wont roll down


Click the link below to troubleshoot the problem:--
Power windows not operating?http://whoisbyme.blogspot.in/2012/05/car-window.html

----------
Thanks.

Jun 07, 2012 | Spyder 03-05 Chevy Silverado Vertical...

1 Answer

My cda-9813 wont power on,how to take of faceplate?


sure it will the face eject button should be either on the upper or lower left corner of the face.

Mar 26, 2010 | Alpine CDA-9813 CD Player

1 Answer

Power windows and power locks wont work


Check your fuses first. Then check for power at the switches, and power from the switches to the respective solenoid and motor. Most likely it's fuses. Also check where the wiring runs through the door into the car for bare spots in the wiring that might have blown the fuses.

Jan 21, 2010 | 2004 Mitsubishi Endeavor

2 Answers

Car wont start and there is no power to it at all. The security light is on?


do you know if you have an anti-thieft device in your car. sounds like it may be armed and connected to your battery.

Oct 18, 2009 | 1995 Jeep Grand Cherokee

1 Answer

My inspiron laptop wont turn on after I replaced


Verify that you obtained an exact replacement power adapter for the Dell. If it is an exact replacement then try this. Disconnect power adapter. Remove battery. Reconnect power adapter without the battery. If it turns on, then power off and place battery back in. Then try again. If problem returns, there could be a problem with the battery itself.

Sep 28, 2009 | Dell Inspiron B130 Notebook

1 Answer

Phone wont power on


i have a change my password and many time i type wrong password then my handset not work
its show jvm error 513

Oct 24, 2008 | AT&T Blackberry Curve 8300 Smartphone

Not finding what you are looking for?
Polaroid TLA-01911C TV Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaroid Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74383 Answers

matt martin
matt martin

Level 3 Expert

1212 Answers

Jaime Hernandez

Level 3 Expert

2318 Answers

Are you a Polaroid Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...